Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Why San Francisco Homeowners Choose Toto Construction
We provide independent Toto construction and service in San Francisco: repairs, replacements, and full bathroom remodels built around Toto fixtures. What makes our Toto work different is that we treat the toilet and washlet as part of the room’s plumbing, not an afterthought bolted in at the end. We’re an independent remodeler, not a factory-authorized agent, and we’re not affiliated with or endorsed by Toto. We source genuine Toto parts, match the brand’s rough-in and trim specs, and coordinate the licensed trades around its fill-valve and washlet plumbing. Homeowners across San Francisco call us at (866) 320-2646 for a free estimate, and a live person picks up, 24/7.
Why Trust Groundwork Construction Co. of San Francisco for Your Toto Construction?
Our technicians have up to 12 years of experience, and a good share of it has been spent on Toto fixtures. They know the Drake’s two-piece tank set, the fill-valve geometry on a Drake II, the Tornado flush tower inside an Ultramax II, and the split flush buttons and inlet valve on an Aquia dual-flush. That matters because Toto doesn’t use universal internals. A generic flapper in a Drake tank will seal unevenly and run. We fit genuine Toto fill valves, flappers and washlet parts wherever the model is still supported, and we match OEM specs on rough-in so the toilet sets level with the finished floor.
We work warranty-safe, which means we don’t crack open a sealed washlet control board or swap in a part that voids the manufacturer’s coverage without telling you first. Everything we install is covered by our 730-Day Done Right Promise: if it’s not done right, we make it right. Pricing is upfront, so the number you see is the number you pay. For a Toto install or repair anywhere in San Francisco, call (866) 320-2646.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Common Toto Construction Problems We Fix in San Francisco
Most Toto calls in San Francisco are not failure of the fixture. They’re failure of a part that’s done its time. Here’s what we see most:
- Drake and Drake II (CST743 / CST454) ghost runs from a scaled tower gasket. The Tornado flush tower gasket warps or crusts over with mineral deposits in harder water, so the toilet refills on its own every few minutes. This is a fill-valve and gasket fix, not a new toilet. We pull the tank, replace the works with the correct Toto part, and verify the seal.
- Ultramax II one-piece running past the fill line. The integrated tank makes the fill valve trickier to reach, and a worn refill tube siphons slowly. The symptom is a faint hiss hours after a flush. People assume the whole one-piece has to go. Usually it doesn’t.
- Aquia dual-flush that keeps running between flushes. On the Aquia, the inlet valve and the split-button linkage wear together. The lever stops lifting the seal cleanly, so it seeps. We replace the assembly and test both flush volumes before we call it done.
- Wax ring and closet-flange leaks on Drake installs. This is the remodel problem. When the rough-in was set shallow and the flange sits below finished tile, the wax ring can’t seal and you get a slow leak at the base. We check flange depth against the finished floor before we reseat, and we correct with a flange extension rather than stacking wax.
- Console lav and undermount sink rims with cracked caulk. The Toto console sinks and undermount basins we service are often fine. The caulk joint around the rim has degraded and re-cracks against normal expansion and the damp San Francisco air. We cut it out, dry the joint and reseal, which is cheaper than replacing a sound fixture.
A common San Francisco call is a Drake that runs intermittently or won’t hold a flush, almost always a worn flapper or a Tornado tower gasket scaled by mineral deposits. A qualified local pro pulls the tank, replaces the fill and flush valve with the correct Toto part, checks the angle stop and supply, and verifies the flange sits level with the finished floor before reseating.
Toto Parts & Our Repair-vs-Replace Approach
Parts get sourced to the job. We don’t claim a local parts stock; we order genuine Toto fill valves, flappers and washlet components for the models that are still supported, and we’ll use quality aftermarket parts where Toto’s pricing is disproportionate to the job. We tell you which is which before we order.
On repair versus replace, we’re honest. A warped gasket or a worn valve is a repair. Replacement is usually only warranted on a cracked bowl or a model Toto has discontinued, where parts dry up. We won’t sell you a new toilet to fix a $30 part. Call (866) 320-2646 and we’ll quote the repair and the replacement side by side, free.
Our Toto Service Process – Step by Step
- 1
Diagnosis. We identify the exact model and series (Drake CST743, Drake II CST454, Ultramax II, Aquia), because the fill and flush internals differ. We watch it flush, check for ghost runs, and check the flange depth against the finished floor.
- 2
Repair or install. We fit the correct Toto part or set the new fixture to the manufacturer’s rough-in spec, checking the angle stop and supply line while we have the tank off.
- 3
Test. We cycle the flush, confirm the tank holds and stops, and test both volumes on a dual-flush unit. On a remodel, we confirm the washlet has power and a supply where it sits.
- 4
Warranty. The work is documented and covered by the 730-Day Done Right Promise. If it’s not done right, we make it right.
See the difference
Before
After
Before
After
Before
AfterToto Products We Service & Install in San Francisco
We service and install the Toto models common in San Francisco homes: the Drake and Drake II two-piece (CST743 / CST454 series), the Ultramax II one-piece with Tornado flush, the Aquia dual-flush, and Toto washlet seats. We also handle Toto console lavs and undermount sinks as part of a bathroom remodel, and we coordinate the rough-in and trim so the fixture lines up with the finished tile. In a dense city of older rows, matching rough-in is most of the battle.
We Also Service These Brands
We’re not a single-brand shop. Alongside Toto, we work with KraftMaid cabinetry, Cambria and Silestone quartz surfaces, and Kohler fixtures, so a bathroom remodel or a kitchen can run through one contractor from foundation to finish line. If your project pairs a Toto toilet with a Cambria vanity top, we handle both.
FAQs – Toto Construction Service in San Francisco
Is Groundwork Construction Co. of San Francisco authorized by Toto? No. We’re an independent Toto service provider, not a factory-authorized agent, and we’re not affiliated with or endorsed by Toto. We source genuine Toto parts and follow the brand’s rough-in and trim specs on our own.
Do you use genuine Toto/OEM parts? Yes, on any model still supported, we use genuine Toto fill valves, flappers and washlet parts. Where Toto’s pricing is disproportionate to the job, we’ll offer quality aftermarket and tell you what you’re getting before we order.
How long does Toto service take? A fill-valve or flapper swap on a Drake is usually done in a single visit. A one-piece Ultramax II or a washlet electronics issue can take longer if a part has to be ordered. We’ll give you the scheduling up front.
What Toto models/series do you cover? The Drake and Drake II (CST743 / CST454), Ultramax II with Tornado flush, Aquia dual-flush, Toto washlet seats, and Toto console and undermount sinks. Tell us the model and we’ll match the parts.
Will service void my Toto warranty? Proper service doesn’t void it, and we work warranty-safe. We won’t open a sealed washlet control board or install a part that voids coverage without telling you. On a supported model, we use the OEM part to keep coverage intact.
How much does Toto construction cost in San Francisco? It depends on the scope. Here’s what our typical bathroom work runs in San Francisco:
| Service | Price Range |
|---|---|
| Bathroom Remodel | $10,620 – $33,040 |
| Walk-In Shower Installation | $5,310 – $14,160 |
| Bathroom Vanity Installation | $945 – $3,540 |
| Small Bathroom Remodel | $5,900 – $14,160 |
A simple Toto repair is a fraction of that. Call (866) 320-2646 for an exact quote on your San Francisco project, estimates are free.
Book Your Toto Service in San Francisco, CA
Whether your Drake runs and needs a part or you’re remodeling the whole bathroom around a Toto fixture, we’ll give you an upfront number and stand behind the work for 730 days. Call (866) 320-2646 to schedule your free estimate in San Francisco today.
Written by the team at Groundwork Construction Co.