A Groundwork company - serving San Francisco, CA

Wellborn Driveway & Pavers in San Francisco, CA

Driveway & paversDriveway & pavers
Kitchen remodelingKitchen remodeling
Bathroom remodelingBathroom remodeling
Home additions & ADUHome additions & ADU
RoofingRoofing
Windows & doorsWindows & doors
FenceFence
Every visit starts with

Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled

We have financing partners for your dream remodel*On approved credit; ask us about your options
Get your free estimate

Wellborn Driveway & Pavers: The San Francisco Owner’s Guide

We install and repair Wellborn driveway and paver systems throughout San Francisco, and a full paver driveway installation here typically runs $8,260 to $21,240 depending on square footage, base prep, and the paver profile you choose. A failed section – cracked units, sunken joints, a border that’s started to walk – usually gets repaired far below that range and can often be scheduled within the same week. Most San Francisco owners find out something’s wrong the same way: a paver rocks underfoot when they pull into the garage, or a joint that was tight last spring is suddenly a half-inch wide.

Call (866) 320-2646

Wellborn makes modular concrete paver systems for residential driveways and walkways, and the parts that matter most in this city are the pavers themselves, the polymeric joint sand, and the edge restraint that holds the field in place. Knowing which one failed is the difference between a $400 fix and a $9,000 tear-out. We’re an independent contractor and aren’t affiliated with Wellborn – we source compatible components and install them to spec across San Francisco.

Which Wellborn Models This Applies To

Wellborn’s residential paver lines run in standard thickness profiles – the common ones are 60mm for walkways and patios and 80mm for driveways that take vehicle loads – and the format widths vary by series, from the classic 4×8 brick to larger 6×9 and 12×12 slabs. The first compatibility check is thickness. If your driveway was built with 60mm units and you patch a failed section with 60mm of a different series, the joint width changes and the new units sit proud or low against the old field. Pull a loose paver and measure it with a tape: thickness, face length, face width. That measurement, not the color name, is what matches your part.

On the OEM-versus-aftermarket decision: Wellborn’s own replacement units are the cleanest color match if the line is still in production, but many of their older series have been discontinued, and a discontinued color is not coming back. In that case we source a quality aftermarket equivalent that matches thickness and face dimensions and we integrate it as a border or a full field section rather than a spot-patch, so a slight shade difference reads as intentional design instead of repair. If your project also touches hardscape fixtures or interior surfaces, we handle KraftMaid, Cambria, and Silestone work the same way – one contractor, one accountability line.

Explore

Styles & brands we work with

  • Kitchen remodeling
  • Bathroom remodeling
  • Home additions & ADU
  • Roofing
  • Windows & doors
  • Driveway & pavers
  • Fence

Signs Your Wellborn Driveway & Pavers Is Failing

Paver failures in San Francisco almost always trace to water and base, not to the paver itself. Here’s what each symptom is telling you:

  • Pavers rocking underfoot. The bedding sand under that unit has washed out or the base beneath it settled. Rocking means the paver is no longer supported, and every load cycle widens the void underneath.
  • Widening joints and sand loss. Polymeric joint sand has failed or washed through. Once joints open, water runs straight into the base instead of shedding off the surface, and the failure accelerates.
  • An edge that’s spreading or heaving. The edge restraint has lifted, cracked, or was never spiked deep enough. In San Francisco’s sandy coastal soils and steep grades, edge restraint does more structural work than most owners realize.
  • Cracked or spalled paver faces. Freeze-thaw is rare here, but salt air and repeated saturation drive spalling in lower-density concrete units. A cracked paver in a driveway field usually means the base has moved, not that the paver was defective.
  • Sunken sections near the garage apron or gutter. Water is pooling and undermining the base at the low point of the slope. This is the one symptom that gets worse fast and the one worth calling about first.
Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

Replacement Cost & What’s Included

Here’s what driveway and paver work actually runs in San Francisco, priced as installed ranges:

Service Installed Price Range
Paver driveway installation (full) $8,260 – $21,240
Concrete driveway installation $5,310 – $14,160
Asphalt driveway paving $4,130 – $10,620
Driveway replacement (full tear-out) $5,900 – $16,520
Paver patio installation $4,130 – $12,980
Driveway sealing $295 – $825

What moves a paver job up or down the range: square footage first, then base depth (a driveway over clay or fill needs a deeper compacted aggregate base than one over native rock), edge restraint and drainage corrections, and whether we’re matching a discontinued Wellborn color. Our pricing is upfront – the number you see is the number you pay, with no change-order surprises once the base is open. Every installation is covered by our 730-Day Done Right Promise, so if a joint opens or a section settles inside two years, we come back and make it right.

DIY or Call Us?

You can safely check a few things yourself: pull one loose paver and measure its thickness and face dimensions, sweep a level across the failing section to see if it’s high or low, and check whether the edge restraint is still spiked or has lifted. What goes wrong with DIY on paver work is the base. Re-bedding a paver on sand without compacting a proper aggregate base, or re-sanding joints with the wrong polymeric product, buys you one season and then the same failure returns – larger. On a driveway taking vehicle loads, a failed base is a structural problem, and a spot fix on top of it just moves the failure sideways.

If a section is rocking or the edge is spreading, call us at (866) 320-2646 and we’ll tell you straight whether it’s a repair or a rebuild. Estimates are free, calls are answered by a live person 24/7, and our technicians have up to 12 years of experience on hardscape and driveway work.

FAQs

Need Construction help nationwide? Licensed & insured · free written estimates
Call (866) 320-2646
Local Service Coverage

Request a Free Estimate in San Francisco

Tell us what you need - Groundwork Construction Co. of San Francisco responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Prefer to text? Text Us
Call Now - 24/7 Dispatch