A Groundwork company - serving San Francisco, CA

Delta Windows & Doors in San Francisco, CA

Windows & doorsWindows & doors
Kitchen remodelingKitchen remodeling
Bathroom remodelingBathroom remodeling
Home additions & ADUHome additions & ADU
RoofingRoofing
Driveway & paversDriveway & pavers
FenceFence
Every visit starts with

Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled

We have financing partners for your dream remodel*On approved credit; ask us about your options
Get your free estimate

Delta Windows & Doors: The San Francisco Owner’s Guide

We install and repair Delta-compatible windows and doors throughout San Francisco, with full window and door replacement typically running $5,310 to $17,700 installed, and impact-rated units at $9,440 to $29,500 when your opening calls for them. Delta covers a wide spread of window and entry-door lines, so the part in your hand or the sticker on your sash matters – the right match is what keeps a repair small. Owners usually find the problem the same way: a sash that drags instead of gliding, a door that won’t latch without a shoulder, or fog between panes that no amount of cleaning touches. That’s a hardware, seal, or glazing failure, and it’s worth pricing before it spreads.

Call (866) 320-2646

We’re an independent service provider, not affiliated with Delta. When we write a part or a replacement, we’re matching it to your actual unit and the way it should perform in San Francisco’s marine air.

Which Delta Models This Applies To

Delta’s residential catalog runs several families: vinyl slider and single-hung windows, awning and casement windows, and hinged patio and entry doors. The failure point you describe usually locates the family. Rollers and tandem roller assemblies fail on sliders and patio doors. Sash balances, pivot bars, and tilt-latch hardware fail on single-hung and double-hung sashes. Hinges, sill sweeps, and threshold weatherstrip fail on hinged doors.

Identify your unit before you buy anything. On most Delta windows, the glass-to-frame spacer and the interior stop carry a label with the series designation and a manufacturing date; the sash itself may have a stamped mark in the top channel. If the label is gone, measure. Measure the visible glass width and height to the nearest 1/16 inch, then the overall frame height and width at the opening. Delta sized its lines to common nominal dimensions, but a 35 1/2-inch sash and a 36-inch sash are not the same part, and the difference is the most common reason a returned roller or balance won’t fit.

On the OEM-versus-aftermarket question, the honest answer for Delta is a split. Tilt latches, pivot bars, and screen hardware have solid quality aftermarket equivalents that cost roughly a third to half of OEM and hold up just as well. Sash balances and roller assemblies are where we stay OEM or OEM-spec; a mismatched balance rated for a lighter sash will let a heavy unit drop within months, and the spring tension ratings don’t cross-reference cleanly between brands. Insulated glass units should be ordered to the exact spacer width and tint to match the rest of your set.

Explore

Styles & brands we work with

  • Kitchen remodeling
  • Bathroom remodeling
  • Home additions & ADU
  • Roofing
  • Windows & doors
  • Driveway & pavers
  • Fence

Signs Your Delta Windows & Doors Is Failing

  • The sash drops or won’t stay open. A worn sash balance has lost its spring tension, or a broken pivot bar let the balance slip off. This is the first thing to check on a single-hung that suddenly won’t hold position.
  • A roller drags or the door jumps the track. Worn tandem rollers or a track that has collected grit and salt air. On San Francisco sliders facing the fog belt, we see this a lot because the rollers sit low and gather debris.
  • Fog or condensation between the panes. The sealed glass unit’s perimeter seal has failed and moisture has entered the airspace. No cleaning fixes this; it’s a glazing replacement, not a hardware swap.
  • The door won’t latch or rubs the strike. Hinge wear, a sagging hinge jamb, or a shifting threshold. In older San Francisco homes, a settling foundation often transfers movement into the door opening and shows up as a latch that used to catch cleanly.
  • Drafts, water staining, or soft weatherstrip. Worn sill sweeps and compressed weatherstrip let the fog and wind in. It shows as a cold edge in winter and staining on the interior sill after a storm.
Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

Replacement Cost & What’s Included

Installed pricing in San Francisco depends on opening size, the material, and whether we’re swapping a part or a whole unit. Here are the ranges we quote:

  • Window replacement (full unit, installed): $5,310 to $17,700
  • Impact-rated window installation: $9,440 to $29,500
  • Part-and-labor repair on a failed balance, roller, or hinge: usually a small fraction of a full swap, priced after we confirm the model and part

The range is driven by unit size, glass package (standard versus impact, low-E, or tinted), the number of openings in the job, and what we find behind the trim – old San Francisco openings sometimes need flashing and reframing that a straight swap doesn’t. We quote parts and labor separately so you see exactly what a matching part costs versus a full unit. Every install is covered by our 730-Day Done Right Promise, and we call the number you see the number you pay.

DIY or Call Us?

Some of this is genuinely a homeowner check. Measure your sash and glass carefully, look for the series label, test a roller by lifting the door slightly, and confirm the fog is between the panes rather than on the glass. What we’d avoid doing yourself is balance and roller replacement on a heavy two-story or door-height unit – the sash can drop, and getting it back in the frame without cracking the glass or pinching your hand is where most DIY attempts go wrong. On a marine-air climate like San Francisco’s, a badly reseated sash also invites leaks fast.

If the unit is big, the glass is fogged, or the door has shifted in its opening, that’s a job for us. Call (866) 320-2646 and we’ll match the right part and quote it upfront – estimates are free.

FAQs

Need Construction help nationwide? Licensed & insured · free written estimates
Call (866) 320-2646
Local Service Coverage

Request a Free Estimate in San Francisco

Tell us what you need - Groundwork Construction Co. of San Francisco responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Prefer to text? Text Us
Call Now - 24/7 Dispatch