Fence
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & paversFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
GAF Fence Installation: The San Francisco Owner’s Guide
GAF isn’t a fence manufacturer – GAF is North America’s largest roofing manufacturer, and the name lands on this page because San Francisco homeowners often search for “GAF fence installation” after a GAF roof or GAF RoofCurb project leaves them wanting the same brand discipline on their fence line. What we install is a GAF-compatible fence installation, and the honest installed price range for San Francisco runs $4,130 to $10,620 depending on material, run length, and grade work. Most residential fence installs in San Francisco complete in a single visit, with the full 730-Day Done Right Promise covering workmanship.
Owners usually end up here after a storm, a neighbor dispute, or a failed post base. The symptom is almost always the same: a gate that won’t latch, a fence that leans an inch inland after the first real rain, or a redwood board that’s gone soft at the base while the rest of the wood looks fine. That last one is San Francisco-specific. Our fog belt keeps lumber damp enough that untreated or improperly flashed post bottoms rot from the ground up while the visible cedar stays healthy for years. By the time the lean shows, the buried post is usually gone.
Which GAF Models This Applies To
There’s no GAF fence SKU. GAF product lines – Timberline HDZ and UHDZ shingles, Royal Sovereign, Liberty, and the RoofCurb and EverGuard commercial systems – are roofing and waterproofing products. If you’re coming from a GAF roof, the connection to your fence is real but indirect: GAF’s own installation standards for corrosion-resistant fasteners, substrate preparation, and edge detailing are the same discipline we apply to fence installs. Homes with a GAF Timberline HDZ roof (50-year limited warranty, 130 mph wind rating) often ask us to match that spec ceiling on the fence line with heavy-gauge hardware and hot-dip galvanized or stainless fasteners.
Where a genuine part match matters: if your fence ties into a GAF-clad wall or shares a footing with a RoofCurb system, the flashing detail at the fence-to-roof junction is the failure point, not the fence. Identify it by walking the junction after rain – dark staining on the roof-side of the fence post means water is tracking through, not around. We source fence materials from the same verified supply channel as GAF-branded components (KraftMaid, Cambria, and Silestone run through the same partner network). We don’t stock parts and don’t carry fence materials on a truck – everything is measured, ordered to spec, and delivered to your San Francisco job site. Groundwork Construction Co. of San Francisco is an independent service provider and is not affiliated with GAF.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your GAF Fence Installation Is Failing
- Posts leaning after rain. In San Francisco’s clay-heavy zones (Sunset, Richmond, parts of Bernal Heights), posts set in concrete without a gravel base trap water at the footing and heave. Leaning is a footing failure, not a post failure – resetting the post without fixing drainage repeats the problem.
- Rot at the base while the top looks fine. Fog and marine layer keep the lower 18 inches of a fence damp for hours longer than the top. Untreated redwood or cedar without a post cap and ground clearance rots from the bottom. If you can push a screwdriver into the wood at grade, the post is compromised.
- Rust bleeding at fasteners. Non-galvanized screws in San Francisco’s salt-air corridor (from the Marina to Ocean Beach) show rust streaks within 3-5 years. That’s a fastener-spec failure, not a paint problem – the fix is stainless or hot-dip galvanized hardware, not touch-up.
- Gate sagging or dragging. A gate that drags after a year is almost always a hinge or post-hinge failure, not a warped gate. Sag concentrates load on one hinge plate, and once that plate tears out of the post, replacing the gate without resetting the post won’t hold.
- Fence pulling away from the house. At the wall attachment, poorly flashed connections let water into the siding. Look for soft siding or dark staining within 12 inches of the fence line – this is the one failure worth addressing before it spreads to the wall.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Installed fence pricing in San Francisco runs $4,130 to $10,620. That range covers removal and disposal of the old fence, new footings set to code, post install, panel or picket install, gate hardware, and site cleanup – parts and labor together, one number. Vinyl fence installation sits at the low-to-mid end of that range ($4,130 to $10,620); aluminum fence installation runs slightly higher ($4,720 to $11,800) because of hardware and gate weight. Redwood and cedar land mid-range depending on run length.
What drives the number up: total linear feet (most San Francisco lots run 80-160 feet of fence line), number of gates, footing depth (deeper on sloped lots), and access. A Sunset-side rear fence with no alley access costs more than a Bernal Heights front fence because materials come in by hand. Licensed, insured, permits pulled where required, and the number you see is the number you pay – no change orders. Every install carries the 730-Day Done Right Promise: if it’s not done right, we make it right. Call (866) 320-2646 for a free line-item estimate.
DIY or Call Us?
The honest split: an owner can safely inspect, measure, and photograph. Checking post lean with a level, testing base wood with a screwdriver, and confirming the linear run are all reasonable. Everything past that gets dangerous or gets expensive. Digging new footings on a San Francisco lot means calling 811 before you dig (gas and utility lines run shallow on many older parcels), and footing depth in clay soil has to go below the frost-and-drainage line or the post heaves within one wet season. Setting a post plumb and getting the gate square to within 1/8 inch is a two-person job with the right jigs – DIY gates that drag after six months are one of the most common repair calls we get.
One safety note up front: any fence that shares a footing with a wall or roof edge, or that stands over a slope, is height work with real fall risk. That’s a job for trained, background-checked, uniformed technicians, not a weekend climb. Call (866) 320-2646 and we’ll talk through your San Francisco install – estimates are free, and calls are answered by a live person 24/7.
FAQs
A properly set wood fence lasts 15-25 years in San Francisco’s fog belt; vinyl runs 20-30 years; aluminum hardware can outlast both. The variable that shortens lifespan most is footing drainage, not material – posts set with a gravel base and ground clearance hold up far longer than the same material set in bare concrete.
Sometimes. A single leaning post, a sagging gate, or a handful of rotted boards can often be repaired for a fraction of replacement cost. If more than about 25% of posts are compromised or the fence is pulling from a wall, replacement is usually the better spend. Call (866) 320-2646 for a free repair-versus-replace assessment.
Most residential fence replacements in San Francisco finish in one to two days, depending on linear feet and gate count. Removal and disposal typically happen the same day as install, so your yard isn’t torn up overnight.
We source fence materials and GAF-compatible hardware through the same verified partner supply channel we use for GAF and Owens Corning roofing and our window and cabinetry partners (Andersen, Pella, James Hardie, Belgard, KraftMaid, Cambria, Silestone). We don’t stock parts locally and don’t carry materials on a truck – every component is ordered to your measured spec and delivered to the job site.
Ready for a real number? Call Groundwork Construction Co. of San Francisco at (866) 320-2646 for a free project estimate and design consult. Live person, 24/7. Upfront pricing, no surprises. $1,000 off projects over $10,000 and 0% financing for 18 months available. Proudly serving San Francisco and nearby areas.
Written by the team at Groundwork Construction Co. of San Francisco, serving San Francisco and nearby areas.