Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
CertainTeed Driveway & Pavers: The San Francisco Owner’s Guide
We install and repair CertainTeed-related driveway and paver systems for San Francisco homeowners, and most paver driveway projects here land between $8,260 and $21,240 installed, depending on square footage, base conditions, and paver selection. A simple concrete replacement runs $5,310 to $14,160, and sealing alone costs $295 to $825. Same-day availability is not realistic for a driveway rebuild; a proper paver install takes planning, permits where required, and dry weather, and we schedule free estimates around your timeline. You usually discover a problem here one of two ways: pavers start heaving or rocking after a wet winter, or a driveway that looked fine in summer shows sunken joints, loose sand, and standing water by February.
Key Takeaways
- CertainTeed paver driveways in San Francisco typically run $8,260 – $21,240 installed.
- Most failures trace back to base prep and drainage, not the pavers themselves.
- We’re an independent contractor and are not affiliated with CertainTeed.
- Every job is covered by our 730-Day Done Right Promise.
Which CertainTeed Models This Applies To
CertainTeed’s hardscape lineup is sold under specific product families, and the paver or slab you have determines which base system, joint sand, and sealer we spec for your San Francisco install. Identifying your product matters because a 60mm interlocking paver built for a residential driveway behaves very differently from a thinner patio paver that was never meant to carry a vehicle. The first step is finding the product label, the original invoice if you have it, or a spare paver the previous installer left behind. Manufacturers stamp or imprint many pavers on the side or underside; pull a loose unit and check the edge for a stamp, then measure length, width, and thickness. Thickness is the tell: driveways need the heavier-duty units, patios can use lighter ones.
Once we’ve identified the family, we decide between matching the original product and a quality aftermarket equivalent. For a small repair, matching the original CertainTeed unit preserves the look and the joint pattern. For a full replacement, an equivalent heavy-duty paver from another trusted brand can sometimes deliver the same performance. Fence-to-fence, we’re an independent contractor, not a CertainTeed dealer or affiliate, so we recommend what actually fits your driveway rather than what’s sitting in inventory. We also work with KraftMaid, Cambria, and Silestone on interior projects, and we quote driveway work with the same upfront pricing, no surprises.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your CertainTeed Driveway & Pavers Is Failing
- Heaving or rocking pavers. This usually means water got under the base and froze or saturated the subgrade. In San Francisco’s wet winters, a driveway that drains poorly will lift at the joints within a season or two.
- Sunken or uneven sections. Settlement points to compacted base that wasn’t deep enough or soil that wasn’t prepped correctly. Clay-heavy lots around the city are especially prone to this.
- Widening joints and washed-out sand. Joint sand migrates out when water moves through the surface faster than the drainage allows. Losing sand lets pavers shift and edge restraints loosen.
- Standing water or poor runoff. A driveway that ponds near the garage or along a slope is usually a grading or slope problem, not a paver problem. Left alone, that water reaches the base and accelerates everything else.
- Cracked, chipped, or spalling units. Heavy vehicle loads on a paver that was meant for a patio, or repeated freeze-thaw at the edges, will chip and crack the surface over time.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Here’s what San Francisco homeowners typically see for driveway and paver work, with parts and labor bundled into a single upfront number:
| Project | Typical Installed Range |
|---|---|
| Paver Driveway Installation | $8,260 – $21,240 |
| Concrete Driveway Installation | $5,310 – $14,160 |
| Asphalt Driveway Paving | $4,130 – $10,620 |
| Driveway Replacement | $5,900 – $16,520 |
| Driveway Sealing | $295 – $825 |
Several things drive the range: total square footage, how much old surface and base has to come out, the paver you choose, and how much grading or drainage correction the site needs. We pull the permits where the city requires them and build to inspection, and every driveway we install is covered by our 730-Day Done Right Promise. The number on your written quote is the number you pay, and we offer 0% financing for 18 months plus $1,000 off projects over $10,000.
DIY or Call Us?
Some checks are safe for any homeowner. You can pull a single loose paver to look for the product stamp, measure thickness, note where water pools after rain, and check whether joint sand has washed out along the edges. What goes wrong with DIY is almost always the base and the grading, not the pavers. Re-laying a few units on top of a failing subgrade just moves the problem a few months out, and a driveway that isn’t graded to drain will keep failing regardless of how carefully the top layer goes back down. Trucks and wheel loads punish shortcuts that a patio would tolerate. If your driveway is heaving, sinking, or pooling water, call (866) 320-2646 for a free estimate. Calls are answered by a live person, 24/7, and estimates are free.
FAQs
A properly installed paver driveway can last decades, and most of that lifespan comes down to base depth, compaction, and drainage rather than the pavers. Around the Bay, wet winters and clay soils test the base more than dry heat does, so a well-built driveway on correct drainage easily outlasts a fast install on a shallow base. Call (866) 320-2646 for an exact assessment of your driveway; estimates are free.
Often yes. Isolated rocking or sunken pavers can sometimes be pulled, the base corrected, and the same units re-set, which costs far less than a full replacement. But if the failure is widespread or the grading is wrong, patching will only buy a little time. We’ll tell you which situation you’re in after we see it. Call (866) 320-2646 for a free estimate.
A small paver repair can finish in a single visit, while a full driveway replacement typically takes several days spread across excavation, base prep, paver setting, and finishing. Weather and access affect the schedule, and we work around wet stretches so the base is dry when it matters. We’ll give you a realistic timeline in your written quote. Call (866) 320-2646 to schedule.
We identify your existing product family or match it with a heavy-duty equivalent, then order from trusted brand partners rather than carrying stock. We don’t stock parts or keep pavers on a truck, so the right materials are ordered for your specific job. That means a correct match and no leftover guesswork. Call (866) 320-2646 for a free estimate.
Written by the team at Groundwork Construction Co. of San Francisco, serving San Francisco and nearby areas.