Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Tamko Driveway & Pavers: The San Francisco Owner’s Guide
Tamko-spec driveway and paver work in San Francisco typically runs $8,260 – $21,240 for a full paver driveway, and most inspections or small part-level repairs can be scheduled within the same week. We work with the pavers, edge restraints, base materials and joint systems that pair with Tamko products, and we quote every job upfront so the number you see is the number you pay. Owners usually discover the problem the same way: a loose or rocking paver near the garage apron, sand washing out of the joints after a storm, or a hairline crack spreading across a paver face after a wet winter. What starts as one wobbly stone in the Sunset is almost always a base or joint failure underneath, not the paver itself.
Which Tamko Models This Applies To
Tamko pavers and hardscape systems are specified by product line, face dimension and thickness, and the model matters more than most homeowners expect. A paver from one line carries a specific nominal thickness (commonly 60mm or 80mm for driveway-rated applications), and mixing thicknesses or edge profiles across a driveway is how you get lippage and premature failures. The fastest way to identify what you have is to check the original project paperwork or a stamped sample, then measure the actual face and thickness with a tape, not by eye. Labels fade and edge stamps disappear after a few wet seasons in San Francisco, so measurement is often the reliable path.
Once you know the line, you face the OEM-versus-aftermarket decision. OEM Tamko-matched pavers give you a true color and dimensional match for a repair, but they carry a premium and can take longer to source on a discontinued line. Quality aftermarket equivalents in the same thickness and rating can match the warranty performance at a lower cost, especially for base, edge restraint and joint sand where the brand stamp matters far less than the spec. For color-critical driveway faces, we lean OEM. For structural components underneath, the spec is what counts. We’re an independent service provider and not affiliated with Tamko.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Tamko Driveway & Pavers Is Failing
- Rocking or loose pavers. This almost always means the base beneath has settled or the bedding layer washed out. In San Francisco’s sandy soils and steep grades, water finds the weak spot fast.
- Sand eroding from joints after rain. Joint sand that disappears every wet season points to either the wrong sand or poor drainage, and the pavers soon shift without the interlock.
- Hairline cracks spreading across a paver face. Cracks that grow after cold nights usually trace to a paver rated below driveway traffic or a subsurface void.
- Lippage, where one paver sits higher than its neighbor. A lip over 3mm is a trip hazard and a sign the base compaction failed. Left alone, it spreads.
- Efflorescence, that white chalky film. It can be cosmetic, but persistent bloom near the garage or a low corner often signals trapped moisture and a drainage problem underneath.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
For San Francisco, paver driveway installation runs $8,260 – $21,240, while a paver patio installs at $4,130 – $12,980. If you’re comparing against a concrete driveway, that starts at $5,310 – $14,160, and asphalt paving runs $4,130 – $10,620. A full driveway replacement sits at $5,900 – $16,520, and routine sealing is $295 – $825. What drives the range on a paver job is square footage, base depth required by your grade, edge restraints, drainage work, and whether the repair is a spot level or a full tear-out and re-lay. Labor and materials are quoted line by line, so you see exactly what the part and the install cost separately. Every job is backed by our 730-Day Done Right Promise, and estimates are free.
DIY or Call Us?
There’s a safe middle ground here, and it’s worth being direct about it. You can check the joint sand, sweep and re-sand a small area, clear debris from a drain line, and note which pavers rock when you press on a corner. That kind of honest observation helps us diagnose fast. Where DIY goes wrong is in the base. Lifting and re-setting a paver without re-compacting the bedding layer is the single most common way a small repair turns into a whole driveway replacement, and cutting pavers to fit edge restraints takes the right blade and a steady line. On a sloped San Francisco driveway, poor drainage work means water heading toward the garage slab. Call (866) 320-2646 for an inspection and a free estimate; we’ll tell you honestly whether it’s a spot fix or a re-lay.
FAQs
A properly installed paver driveway holds up 25 to 50 years in our climate, but the pavers aren’t usually what fails first. The base and joint sand are. San Francisco’s wet winters and clay-heavy pockets test drainage every season, which is why base prep and joint maintenance decide the real lifespan. Call (866) 320-2646 for a free estimate on your specific driveway.
Usually yes, if the failure is isolated to one or two pavers and the base underneath is still sound. A spot re-lay with fresh bedding and joint sand fixes most single-paver issues. If the whole base has settled, a partial tear-out and re-lay is the honest fix, and a replacement is only needed when the pattern and grading are already lost. Call (866) 320-2646 for a free inspection and estimate.
A spot repair for one or two pavers is often a single visit, and larger re-lays depend on square footage and how much base needs re-compacting. We give you a realistic timeline with your written estimate instead of promising a same-day fix. Call (866) 320-2646 to schedule your free estimate.
We match by product line, measured thickness and face dimension, then confirm whether OEM or a spec-matched equivalent gives you the better result for your repair versus a wider re-lay. For color-critical driveway faces we lean OEM; for base, edge and joint components we go by spec. We confirm quantities and compatibility in writing before work starts, with no change orders on the agreed scope. Call (866) 320-2646 for your free estimate.
Written by the team at Groundwork Construction Co. of San Francisco, serving San Francisco and nearby areas.