Fence
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & paversFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Mr-Glass Fence Installation: The San Francisco Owner’s Guide
We install Mr-Glass fence systems across San Francisco, and the installed price for a full fence installation typically runs $4,130 to $10,620 depending on run length, panel type, grade, and gate count. We are an independent service provider, not affiliated with Mr-Glass, and we quote the work in writing before anything gets ordered. Most fence installations are planned jobs, so we schedule them properly rather than promising a same-day arrival.
Owners usually figure out something is wrong one of two ways: the gate that used to close with a two-finger push now drags on the ground, or a post starts leaning after a wet winter and never comes back. In San Francisco, where fog rolls through the Sunset for weeks and the ground stays damp, the leaning post is the more common first sign. Below is how to match your system, what fails, what replacement costs, and when to call us at (866) 320-2646.
Which Mr-Glass Models This Applies To
Mr-Glass builds several fence lines, and the part that fits yours depends on the series. The two things that decide compatibility are the post spacing and the rail-to-post connection: a system built on nominal 8-foot post spacing takes different hardware and panel widths than one set at 6 feet, and the glass or panel retention clips are not interchangeable between a framed and a frameless line. Check the identification label on the inside face of a gate post or the top rail cap. Look for a series designation and a manufacture date stamp. If the label is gone or sun-faded, measure your actual post spacing center-to-center, note the panel thickness in millimeters, and photograph the top rail profile where the panel seats. Those three facts let us match the right replacement part instead of guessing.
On the OEM-versus-aftermarket question, the honest answer is that it depends on the part. Framed glass panels and structural posts are worth sourcing to Mr-Glass spec. Clips, gaskets, base plates, and gate hinges have solid aftermarket equivalents that meet the same load rating, and they cost less. We tell you which is which on the written quote. We do not keep Mr-Glass parts on hand and we don’t promise a part is “on the truck.” We source the correct one and install it. We also work with KraftMaid, Cambria, and Silestone on interior projects, but this page is about fence.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Mr-Glass Fence Installation Is Failing
Fence systems rarely fail all at once. They telegraph it first. These are the five symptoms we see most often in San Francisco yards:
- A post that leans and won’t reset. In coastal San Francisco soil, posts set with too little concrete or without drainage fail at the base first. The lean is a footing problem showing up top.
- A gate that drags or binds. Sagging hinges, a swollen frame, or a post that shifted a quarter inch. Look at the hinge side of the post for a hairline crack running up from the concrete.
- Rattling or loose glass or panels. Retention clips and gaskets compress over time. Once the gasket goes, the panel moves in wind and the clip loads up until it cracks.
- Rust bleeding at fasteners and hardware. San Francisco’s salt air eats cheaper fasteners fast. Brown streaks running down a post or panel edge mean the fastener is already compromised.
- Visible gaps at panel-to-post joints. A gap that grows season to season tells you the frame is working loose from the post, and that’s when panels chip at the edge.
Replacement Cost & What’s Included
For San Francisco fence work, a full Mr-Glass installation runs $4,130 to $10,620 installed. Where you land in that range comes down to run length, panel type, post count, gate count, and footing conditions. Hillside lots and yards with old concrete to remove push toward the top. Flat runs with open access stay near the bottom.
| What drives cost | Why it matters in San Francisco |
|---|---|
| Linear feet of fence | More posts, panels, and hardware along the run |
| Panel type and thickness | Heavier panels need stronger posts and hardware |
| Footing conditions | Coastal soil, slope, and old concrete removal |
| Gates | Gate hardware and swing clearances add labor |
Every quote is a line-item breakdown: parts, labor, and permit fees where the City requires a fence permit. Pulling a fence permit in San Francisco depends on height and location, and we handle that on jobs where it applies. The number you see is the number you pay. Workmanship is covered by the 730-Day Done Right Promise, our two-year guarantee that if it’s not done right, we make it right.
See the difference
Before
After
Before
After
Before
AfterDIY or Call Us?
Some things are safe to check yourself. You can walk the line, push on each post, open and close every gate, and look for rust streaks or loose clips. Photos of a leaning post, a dragging gate, or a cracked clip tell us a lot before we ever get there.
Where DIY goes wrong is the footing and the structural panel fit. Resetting a leaning post means digging out the old concrete, setting the new one at the right depth in local soil, and getting it plumb. A panel that’s reinstalled out of square chips at the edge within a season, and then you’re buying a panel too. On glass panels the weight is real, and a dropped or pinched panel is a replacement, not a repair. Better to have us look. Calls are answered by a live person 24/7, and estimates are free. Call (866) 320-2646.
FAQs
Framed Mr-Glass fence systems typically hold up 15 to 25 years, but hardware and gaskets are the first things to go, usually in 6 to 10 years, because of salt air and fog. Regular inspection catches clip and fastener wear before it reaches the panel. Call (866) 320-2646 for an assessment.
Often yes. Leaning posts, hardware, clips, and single panels are repairable without tearing down the whole run. When several posts in a row are failing at the footing, replacement makes more sense, and we’ll say so plainly rather than sell you a repair that won’t hold. Call (866) 320-2646 for a free estimate.
A single post or gate hinge repair is a short visit. A full replacement is a planned multi-day job that depends on run length and how many footings need digging. We’ll give you a schedule with the quote, and we don’t promise a same-day install on planned work. Call (866) 320-2646 to schedule.
We match to your series label, or to your measured post spacing, panel thickness, and rail profile if the label is gone. Then we tell you on the written quote whether OEM or a qualified aftermarket equivalent is the right call. Every job carries the 730-Day Done Right Promise.
Get Your Free Mr-Glass Fence Estimate
If you’ve got a leaning post, a dragging gate, or a loose panel, we’ll come out, match the right part to your system, and give you a line-item price in writing. Plans are backed by the 730-Day Done Right Promise and handled by background-checked, uniformed technicians. Call (866) 320-2646 to schedule your free estimate. Live person, 24/7.
Written by the team at Groundwork Construction Co. of San Francisco, serving San Francisco and nearby areas.