A Groundwork company - serving San Francisco, CA

James Hardie Driveway & Pavers in San Francisco, CA

Driveway & paversDriveway & pavers
Kitchen remodelingKitchen remodeling
Bathroom remodelingBathroom remodeling
Home additions & ADUHome additions & ADU
RoofingRoofing
Windows & doorsWindows & doors
FenceFence
Every visit starts with

Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled

We have financing partners for your dream remodel*On approved credit; ask us about your options
Get your free estimate

James Hardie Driveway & Pavers: The San Francisco Owner’s Guide

We install James Hardie-spec driveway and paver systems across San Francisco, and typical installed pricing runs from $8,260 to $21,240 for a paver driveway and $4,130 to $12,980 for a paver patio. We’re an independent service provider, not affiliated with James Hardie. Most owners discover a failure the same way: a paver lifts at the driveway apron after a wet winter, or the hardscape board edging cracks along a Sunset curb where the fog never quite dries. Once water gets under the field, the problem compounds.

Call (866) 320-2646

Which James Hardie Models This Applies To

James Hardie’s exterior line is built around fiber cement, and while the brand is best known for siding, trim, and the HardiePlank and HardiePanel families, its hardscape-adjacent products and finish systems are specified in San Francisco driveway and paver assemblies more often than most owners realize. If your home has a fiber cement fascia board, a HardieBacker underlayment under a patio border, or a fiber cement edging strip, we can identify what you’re running before we quote.

The compatibility gotcha: James Hardie does not publish a single “driveway paver” part number the way it does for lap siding, so the correct match is by dimension and profile, not a model label. Measure the thickness (fiber cement trim typically runs 5/16 to 1 inch) and the width of the piece, photograph the back stamp if there is one, and note where it sits in the assembly. That identification step is where most inexperienced crews guess and get it wrong.

For OEM versus aftermarket on a James Hardie system, OEM matching matters for exposed edges and any piece that carries the weather seal, because a color and texture mismatch is obvious on a street-facing driveway in San Francisco. Interior aftermarket trim is far more forgiving. Because we’re a curated partner rather than a parts warehouse, the honest answer is: we source and install, we don’t sit on hardscape stock.

Explore

Styles & brands we work with

  • Kitchen remodeling
  • Bathroom remodeling
  • Home additions & ADU
  • Roofing
  • Windows & doors
  • Driveway & pavers
  • Fence

Signs Your James Hardie Driveway & Pavers Is Failing

  • Lifted or rocked pavers at the apron: Water is getting under the base course and freezing or pumping it loose, which is the first failure we see after a heavy San Francisco rainy season.
  • Cracked or crumbling fiber cement edging: The trim board has absorbed moisture or the finish has failed at the ground contact point, and the piece needs replacement before it spreads.
  • Hairline cracks in the field: Settlement in the sub-base, often from an undersized gravel layer, opens joints that then take on water.
  • Weeds and sand loss through the joints: The joint sand has washed out, which means the drainage path is being bypassed and the base is degrading.
  • Color fading or chalking on the surface: UV and salt air in San Francisco wear the finish, and a chalky surface signals the protective layer is gone.
Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

Replacement Cost & What’s Included

In San Francisco, a paver driveway installation runs $8,260 to $21,240, a paver patio installation runs $4,130 to $12,980, a concrete driveway installation runs $5,310 to $14,160, asphalt paving runs $4,130 to $10,620, and a full driveway replacement runs $5,900 to $16,520. Sealing alone is $295 to $825.

The range is driven by square footage, base excavation depth, the condition of the existing slab or subgrade, and whether we’re matching an existing James Hardie finish piece or replacing a full assembly. You get a written line-item quote before work starts, so the parts, the excavation, and the labor are all on paper. Every job carries our 730-Day Done Right Promise: if it’s not done right, we make it right. Upfront pricing, no surprises.

DIY or Call Us?

An owner can safely check a few things: photograph the failing paver or trim piece, measure the thickness and width, note whether water pools toward the house, and look for a back stamp. That information helps any crew quote accurately.

Where DIY goes wrong on a James Hardie assembly is the base. Lifting pavers and re-setting them without correcting the subgrade or drainage simply kicks the failure down the road, and setting fiber cement edging without the right ground contact detail invites moisture damage. This isn’t dangerous work in the way springs or electrical panels are, but it is base-work, and a bad base in a San Francisco clay-and-fog climate fails faster than anywhere else in the Bay.

Most jobs are completed in a single visit once the site is prepped. Call (866) 320-2646 and a live person answers, 24/7. Technicians are background-checked and arrive in uniform.

FAQs

Need Construction help nationwide? Licensed & insured · free written estimates
Call (866) 320-2646
Local Service Coverage

Request a Free Estimate in San Francisco

Tell us what you need - Groundwork Construction Co. of San Francisco responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Prefer to text? Text Us
Call Now - 24/7 Dispatch