Home additions & ADU
Kitchen remodeling
Bathroom remodeling
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Tub-to-Shower Conversion in Tamalpais-Homestead Valley, CA
A tub-to-shower conversion in Tamalpais-Homestead Valley typically runs $3,500 – $10,000 and takes three to six working days once the permit clears Marin County. The job means removing the tub and its surround, reworking the drain and mixer if you’re moving fixtures, then waterproofing and setting a low-threshold shower pan, tile, and glass. On the steep, wooded lots up here that leaves a lot of room between the low and high end, and the walkthrough is where we pin your number down. Call (866) 320-2646 for a free on-site estimate.
How a tub-to-shower conversion actually runs, stage by stage
We don’t treat this like a swap. Every conversion follows the same five stages, and knowing what you decide at each one is how you keep the schedule from stretching.
Stage 1 – Site visit and scope lock (about 60-90 minutes). We measure the alcove, check the tub’s rough opening, confirm the drain location and size, and poke at the wall behind the surround. In these post-and-beam homes the surprise is usually moisture damage in the substrate or a vent stack in the way. You decide the footprint: keep the existing alcove or push the shower into an adjacent closet. We leave with a written line-item scope, not a verbal ballpark.
Stage 2 – Permits and material selections (one to two weeks). A shower conversion that relocates the drain, changes the valve, or adds new circuits needs a County of Marin plumbing and electrical permit. We pull it and coordinate the inspection. During this window you pick tile, pan type, valve finish, and glass. Locking these now is what keeps Stage 4 from stalling.
Stage 3 – Demo and rough-in (day one to day two). Tub out, surround down to the studs, old drain cut free. We inspect the framing for rot and set the new drain and mixer. If anything behind the wall is rotten or the slope of the drain line won’t work, this is the day it surfaces, and we show you before we quote the fix. Rough-in inspection happens here.
Stage 4 – Waterproofing and tile (day three to day five). Cement board or a bonded waterproofing membrane goes up, the pan is set and flood-tested, then we tile walls, curb, and floor. This is the longest stretch and where careful, unhurried work shows ten years later. Tile sets and cures before we touch grout or glass.
Stage 5 – Fixtures, glass, and walkthrough (final day). Valve trim and head install, glass goes up, silicone cures, then we walk the finished shower with you: slope, sealant, caulk lines, drain. No punch list left dangling.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The options you’ll choose between for your Tamalpais-Homestead Valley shower
Most of the cost swing comes from the four decisions below. Here’s the honest trade-off on each, not a sales sheet.
- Tile material. Porcelain is the workhorse – dense, easy to keep clean, and the sensible choice for a wet zone. Natural stone (Marble, Slate) looks richer but needs sealing and shows soap scum on honed finishes. Large-format tile cuts grout lines and reads cleaner in a small shower.
- Shower pan. A tiled mud-set pan is the traditional build and gives you a seamless floor. A prefabricated acrylic or composite pan is faster, cheaper, and forgiving on drainage if the subfloor is out of level – worth considering in these hillside homes where slope and structure are already the story.
- Glass. Framed glass is more affordable and slightly less prone to leaks at the hinges; a frameless panel reads more open in a tight alcove. Both hinge on a level threshold, which we check during rough-in.
- Valve and trim. Keeping the existing pressure-balance valve can save a chunk of labor and permitting on the plumbing side. A new thermostatic valve gives better temperature control and is easier to service later. Kohler trim holds up well and stays in stock locally.
- Wall surround vs. full tile. A full tile wall to the ceiling is the durable choice; a partial-height tile with a painted upper wall is a money-saver if your priorities sit elsewhere in the bath.
What does a tub-to-shower conversion cost in Tamalpais-Homestead Valley, CA?
Expect $3,500 – $10,000 for the conversion itself. That spread is not arbitrary – four variables push a job toward one end or the other.
- Size and footprint. A standard 60-inch alcove sits at the low end. A wider walk-in that pushes into a closet or steals square footage from the bath adds framing and labor.
- Existing condition. Rotted framing, a soft subfloor, or corroded drain cast iron all get discovered on demo day. In this valley’s older homes, moisture damage is the single biggest swing factor.
- Moving plumbing or electrical. Keeping the drain where it is and reusing the valve is the cheap path. Relocating the drain or adding a light and vent circuit triggers more rough-in and more inspection.
- Material grade. Porcelain and a prefab pan land low; slab stone and frameless glass climb reliably.
Your written estimate itemizes demolition, rough-in, waterproofing, tile, fixtures, glass, permit, and inspection – the number you see is the number you pay, and change orders only happen if you approve them after we show you the problem. What typically isn’t included: structural repair behind a rotten wall, drain-line replacement beyond the shower, or moving the shower to a different corner of the room.
See the difference
Before
After
Before
After
Before
AfterWhat Tamalpais-Homestead Valley homes do to this exact job
Permitting here runs through the County of Marin, not a city hall, and that matters for scheduling – inspections are the gate on every stage, so a tight, realistic window beats a rushed promise. Homes tucked under coast redwoods on the valley’s north-facing slopes stay damp and shaded, and the moisture works its way into the wall behind a tub until the surround comes loose or the framing goes soft. We see it most on the shaded ridge lanes and the older post-and-beam homes off the winding private drives where a normal delivery truck can’t turn around; staging a dumpster and material drop needs planning before day one. The surrounding wildland-urban interface also means fire-hardening sensibilities run through the whole house, so a bathroom that keeps moisture out and doesn’t add a problem is worth doing right the first time.
If your bath is part of a bigger change, the conversion slots naturally into Bathroom Remodeling in Tamalpais-Homestead Valley, and homeowners often pair a waterproofed shower pan with Tile Roofing in Tamalpais-Homestead Valley when a leak has already tracked down an interior wall. We cover the whole valley through our Tamalpais-Homestead Valley service area, and when a flat or shed roof is part of the same moisture fix, Metal Roofing in Tamalpais-Homestead Valley is the other job we field the most here. The broader scope lives on our Bathroom Remodeling service page if you want to see how a shower fits a full renovation.
Serving Tamalpais-Homestead Valley, CA – Our Local Coverage Area
We serve Tamalpais-Homestead Valley and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked – Tub-to-Shower Conversion in Tamalpais-Homestead Valley
Three to six working days of on-site work, plus one to two weeks for permitting and material lead time. The active build is fast; the permit and selection window is the part that sets the schedule. Call (866) 320-2646 and we’ll walk your timeline before you commit.
Usually yes, if the drain, valve, or electrical changes – which means a County of Marin permit and inspection. A straight tile-and-pan swap that reuses everything may not require one, and we’ll tell you which yours is. Call us to confirm before work starts.
Often, yes – many conversions keep the drain and valve in place and change only the surround and pan. Moving either adds rough-in, inspection, and cost. We’ll tell you on the first visit whether keeping them earns you the low end. Call (866) 320-2646 to schedule.
$3,500 – $10,000, driven mainly by size, existing moisture damage, plumbing moves, and material grade. The written estimate itemizes each line, and estimates are free. Call (866) 320-2646 for an exact quote.
Not without your sign-off. If we find rot or a plumbing surprise on demo day, we show you the problem and quote the fix before touching it – no hidden change orders. That number is covered by our 730-Day Done Right Promise, in writing. Call to get your estimate.
Get a free tub-to-shower conversion estimate in Tamalpais-Homestead Valley
Book a free on-site estimate and we’ll measure the alcove, check the wall behind the tub, and hand you a written line-item number for your Trabuco conversion – with the permit and inspection included in the scope. Call (866) 320-2646 and a live person answers, day or night. Financing at 0% for 18 months and $1,000 off projects over $10,000 are on the table. The number you see is the number you pay.
Written by the team at Groundwork Construction Co.