Windows & doors
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
CWS Windows & Doors: The San Francisco Owner’s Guide
We install and service CWS-compatible windows and doors throughout San Francisco, with full window replacement typically running $5,310 – $17,700 and impact-rated units at $9,440 – $29,500 installed. Most owners find us after a symptom, not a model number: a sash that won’t latch against the jamb, fog between panes after a foggy San Francisco morning, or a door that suddenly drags on the threshold when the marine layer rolls in. The hardware and glazing unit failed first; the window frame is usually still fine. That distinction decides whether you’re pricing a part or a whole unit, and it’s the first thing we check on site.
Key takeaways:
- CWS uses proprietary sash, hinge and glazing profiles – aftermarket hardware often won’t seat.
- Measured inside the frame, not outside the trim.
- Fogged insulated glass is a glazing failure, not a window failure.
- Our technicians have up to 12 years of experience and every job carries our 730-Day Done Right Promise.
Which CWS Models This Applies To
CWS shipped windows and doors across several eras of production, and the part you need depends on which era your unit came from. Earlier lines used a fixed hinge geometry on casement and awning operators; later lines moved to adjustable friction stays and a different sash balance. Two windows that look identical from the street can take completely different hardware, which is why we don’t quote a CWS part from a photo or a homeowner’s description alone.
The first step is identification. Look for the manufacturer label, usually on the head jamb or the upper track of a sliding unit, stamped with a series code and a date. If the label is missing or painted over, we measure the frame opening and the sash independently – both, not just one. A common compatibility gotcha in San Francisco: a sash measured at 1/8 inch over spec will not seat in a CWS frame even though it “fits” by tape measure, because these frames have almost no allowance at the weatherstrip line. We’ve seen that gap turn into a two-week wait for the wrong part.
On the OEM-versus-aftermarket question, our answer is plain. For CWS glazing and structural hardware – hinges, sashes, operator arms – an OEM-matched part is worth the wait. The tolerances are tight and the weatherstrip sits exactly where it was engineered to. For cosmetic hardware like handles and locksets, a quality equivalent is fine. We’re an independent service provider, not affiliated with CWS, so we source the right part for your unit rather than pushing a single brand’s catalog.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your CWS Windows & Doors Is Failing
Symptoms point to different parts, and knowing which is failing saves you from replacing a sound window. Watch for these:
- Fog or condensation between panes. The insulated glass unit’s seal has failed and moist air is trapped inside. No amount of cleaning fixes it; the unit or the glazing gets replaced.
- The sash won’t latch, or pops open on its own. A worn sash lock, an out-of-alignment hinge, or a frame that has shifted. Often a hardware fix, occasionally a realignment.
- The door drags on the threshold. In San Francisco, humidity swings and the odd earthquake settle push a door out of square. The hinge or the frame, not always the door, is the culprit.
- Water streaks or soft wood at the bottom rail. The weatherstrip or sill gasket has failed and water is getting past it. Caught early, it’s a seal job; ignored, it’s rot.
- A draft you can feel at the edge. Worn weatherstrip or a failed sweep. Cheap to fix, but a real energy leak and a real comfort problem.
Each of these has a cause worth naming before you spend money. We diagnose the part, then talk options.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Installed pricing for San Francisco depends on which part failed and how much of the assembly moves with it. Here’s how it lays out:
| Scope | Installed range in San Francisco |
|---|---|
| Window replacement (full unit) | $5,310 – $17,700 |
| Impact-rated window installation | $9,440 – $29,500 |
What drives the range: window size and count, whether the frame is being replaced or the existing frame is retained, glass type (standard versus impact-rated), and the access. A second-story rear unit over a stair is a different job than a ground-floor front window, and we price it that way. What’s included is always the same story: parts plus labor in a written line-item quote, no change orders once work begins, and our 730-Day Done Right Promise on the workmanship. Upfront pricing, no surprises – the number you see is the number you pay. If the failure is a glazing unit or a single hardware part rather than a whole window, the cost is well below the ranges above, and we’ll tell you so.
DIY or Call Us?
Some checks are safe to do yourself. Confirm the label and series code, measure the sash and the frame opening, note whether the fog is between the panes or on the glass, and test the latch by hand. That information helps us quote accurately.
Where it goes wrong: sealed glazing units are factory-sealed, and prying them apart to “reseal” the desiccant does nothing but crack the glass. Springs and tensioned sash hardware on some CWS units are under load, and a sash that releases unexpectedly can drop or snap – that’s a job for a trained technician, not a Saturday afternoon with a screwdriver. Doors that drag because the frame has moved need the frame corrected, not the door planed, and planing a door is the wrong fix that costs more later. When in doubt, call (866) 320-2646 and we’ll tell you honestly whether you’re looking at a part or a panel.
FAQs
Figure 20 to 30 years for a quality CWS window and door assembly, with the glazing unit often the first thing to go at 10 to 15 years. San Francisco’s salt air and fog accelerate seal and hardware wear on the ocean-facing side of a home – units facing west toward the Pacific tend to fail sooner than sheltered ones. Call (866) 320-2646 to have yours assessed – estimates are free.
Yes, often. A fogged pane or a worn hinge is a part replacement, and the window stays. Whether repair makes sense depends on the frame’s condition: a solid frame is worth the part; a rotted or out-of-square frame turns a part swap into a partial replacement. We diagnose both before quoting. Call (866) 320-2646 for an honest answer and an exact quote.
Most single-part jobs – a glazing unit, a hinge, a weatherstrip set – finish in a single visit. A full window replacement depends on count and access, so we schedule it as its own job and tell you the timeline up front. Every installation is covered by our 730-Day Done Right Promise. Call (866) 320-2646 to schedule your free estimate.
We identify the series from the label and measurements, then match to an OEM or quality aftermarket part for that exact unit. We’re independent of CWS and don’t restrict ourselves to one supplier’s catalog, so you get the right part rather than whatever is closest. We also source KraftMaid, Cambria, and Silestone for other parts of the home. Call (866) 320-2646 – a live person answers, 24/7.
When a CWS window or door fails in San Francisco, the part – not necessarily the whole unit – is usually the problem, and matching it correctly is the whole job. Groundwork Construction Co. of San Francisco serves San Francisco homeowners with upfront pricing, materials built to last and backed in writing, background-checked, uniformed technicians, and a 730-Day Done Right Promise on the work. We also offer free project estimates and design consults, 0% financing for 18 months, and $1,000 off projects over $10,000. Call (866) 320-2646 for a free estimate and let’s get your CWS unit back to doing its job.
Written by the team at Groundwork Construction Co. of San Francisco, serving San Francisco and nearby areas.