Roofing
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
ES Windows Roofing in San Francisco: The Owner’s Guide
ES Windows roofing components in San Francisco are typically repaired or replaced for $470 to $2,125, and most flashing and trim failures can be diagnosed and scheduled within a single visit. We install roofing and weatherproofing that integrates with ES Windows window and door systems across San Francisco homes, and we work from your model number, not guesswork. Owners usually find the problem the same way: a dark stain on the ceiling after a storm, a soft spot near the window head, or water tracking down the interior jamb. Call (866) 320-2646 and a live person answers day or night.
Key Takeaways
- Roof repair tied to ES Windows openings in San Francisco runs $470 to $2,125 installed.
- Full roof replacement, when the leak is structural, runs $9,440 to $23,600.
- Fogged seals are a window problem, not a roofing one. We’ll tell you which you have.
- 730-Day Done Right Promise backs every job in writing.
Which ES Windows Models This Applies To
ES Windows builds window and door systems, so the “roofing” side of your concern belongs to the flashing, head trim, and penetration seal that ties those units to your roof. If your ES Windows unit was installed with a builder-grade pan flashing or a caulk-only perimeter, that interface is where San Francisco rain finds its way in. ES Windows product lines differ in frame depth and nailing flange profile, and headers on their slider and picture units sit wider than a standard double-hung. That matters because the flashing detail has to match the actual flange, not a nominal size.
To identify what you have, pull the sticker inside the jamb or on the head of the operable unit. It lists the series and unit size. If the label is gone, measure the frame face to face and the flange width; we cross-reference that against the ES Windows assembly. We source OEM flashing profiles when they’re available and spec-equivalent aftermarket head flashing when they aren’t, and we tell you which one you’re getting before the quote is signed.
One compatibility gotcha: the flange on older ES Windows units is narrower than current stock profiles, so a generic pan flashing won’t seat flush. We fabricate to the measured flange rather than bending a stock piece to fit. Groundwork Construction Co. of San Francisco is an independent service provider, not affiliated with ES Windows.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your ES Windows Roofing Is Failing
- Ceiling stain below the window head. Water is getting past the head flashing and following the framing. By the time the stain shows in San Francisco, the drywall has usually been wet for weeks.
- Soft or spongy decking near the opening. Repeated moisture has reached the sheathing. This is the point where a $470 repair can turn into a decking replacement.
- Peeling paint or bubbling at the interior jamb. Trapped moisture pushing through the wall finish. Fogged glass is a separate failure (a seal issue, not a roof issue), and we’ll tell you which you have instead of selling you a roof repair you don’t need.
- Visible gaps at the flange or head trim from the attic side. Missing or failed sealant at the perimeter. That’s the interface we rebuild.
- Granule loss and curling shingles on the roof plane above the window run. Wind-driven rain on a west-facing San Francisco wall hits that plane hardest. If the shingles are shot, the leak isn’t the window’s fault.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
In San Francisco, roof repair tied to an ES Windows opening runs $470 to $2,125 installed, and tile roof repair runs $710 to $2,950. Full roof replacement, when the decking is compromised or the shingles are past their service life, runs $9,440 to $23,600. Metal roof installation, if you’re upgrading, runs $17,700 to $47,200.
The range is driven by decking condition, how much flashing has to be fabricated, and whether the repair is a single penetration or a full window run. Our quotes are line-item and upfront: flashing, sealant, decking repair, and labor all broken out. The number you see is the number you pay, and the work is covered by the 730-Day Done Right Promise. Projects over $10,000 get $1,000 off, and 0% financing for 18 months is available.
DIY or Call Us?
You can safely check a few things yourself: look for interior staining below the window head, photograph the gap at the exterior trim, and pull the jamb sticker for your ES Windows model number. That’s the extent of it. Roof work puts you on a pitched surface, and a fall from a San Francisco roofline is not a $200 mistake. Flashing repair done wrong also hides for a season and then shows up as a rotted header.
The repair itself is a trained-professional task. Our technicians have up to 12 years of experience, arrive in uniform and are background-checked, and carry the tools to fabricate a flashing profile on the spot. Call (866) 320-2646 to schedule a free estimate.
FAQs
A properly flashed and sealed repair typically lasts 10 to 15 years in San Francisco’s coastal climate, though salt air and fog exposure on west-facing walls can shorten that. We spec UV-stable sealant rated for marine conditions, not the general-purpose caulk that fails first. Call (866) 320-2646 with your model number for a specific assessment.
Sometimes yes. If the flange and decking are sound, we can re-seal and re-flash the perimeter without removing the ES Windows unit. If the decking under the opening is soft, replacement is the only honest answer, and we’ll show you the failed section before quoting. Call (866) 320-2646 to schedule the diagnostic.
A single-opening flashing repair, once scheduled, is usually completed in one visit; a full roof run over a bank of ES Windows units takes longer because the sheathing has to dry and get inspected. We give you the timeline in writing before work starts, not a vague estimate.
We source OEM profiles when available and spec-equivalent fabricated flashing when they aren’t, and we always tell you which before the quote is signed. You’ll get the part description, the sealant spec, and the labor line in writing. Call (866) 320-2646 for the free estimate.
We also work on KraftMaid, Cambria, and Silestone projects if your San Francisco home has other work on the list.
From foundation to finish line. Whether it’s a window-run leak or a full roof, Groundwork Construction Co. of San Francisco handles it with upfront pricing, no surprises. Call (866) 320-2646 for a free estimate and design consult. A live person answers 24/7.
Written by the team at Groundwork Construction Co. of San Francisco, serving San Francisco and nearby areas.