Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Moen Driveway & Pavers: The San Francisco Owner’s Guide
We install and repair Moen-compatible driveway and paver systems across San Francisco, and most jobs fall between $8,260 and $21,240 installed for a paver driveway, with concrete options running $5,310 to $14,160. A failing Moen paver joint or drainage edge usually shows up first as a hairline crack at a corner, a paver that rocks underfoot, or sand washing out of the joints after rain. Most owners notice the problem after a storm pushes water toward the garage or a low spot in the drive starts pooling.
Which Moen Models This Applies To
Moen paver systems are built around a specific joint and base profile, and matching the right replacement component means confirming the paver thickness and the joint width before any work starts. The most reliable way to identify what you’re dealing with is to measure a single paver’s length, width, and depth, photograph the underside stamp if there is one, and check the joint width between pavers with a tape. That measurement set tells you whether you’re working with a standard 60mm or heavier 80mm profile, which drives the base depth and the joint material you’ll need.
For Moen specifically, OEM parts come with exact dimensional match to your existing run, so a replaced paver sits flush without cutting adjacent units. Quality aftermarket equivalents can work well on a repair of one or two units, but they rarely match the colorfast dye and surface texture of Moen’s stock runs over time. On larger repairs, or when the base has failed under the pavers, aftermarket is a budget shortcut that costs you twice. We’re an independent service provider and not affiliated with Moen, so we source what fits your model rather than what’s on a shelf. We also work with KraftMaid, Cambria, and Silestone across other projects.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Moen Driveway & Pavers Is Failing
- Paver rocking underfoot. This is almost always a base failure, not a paver failure. The sand or aggregate base beneath has lost compaction, usually from water infiltration at a joint or a downspout dumping onto the drive.
- Widening joints with sand loss. Joint sand washes out faster in San Francisco’s wet winters than owners expect, especially on a slope. Once joints open past about 3/8 inch, the pavers move against each other and chip at the corners.
- Hairline cracks at paver corners. Hairline cracks at corners and edges mean the paver is being loaded off the base, either from a heaved section or a missing edge restraint. Left alone, a hairline becomes a broken paver in one season.
- Water pooling against the garage or foundation. This points to a failed slope or a blocked drainage edge. In San Francisco, where lots are tight and grades are steep, water pooling against a garage slab isn’t cosmetic; it drives foundation moisture.
- Efflorescence (white chalky bloom) across the surface. Efflorescence means moisture is moving through the paver from below, which usually traces back to a base that isn’t draining. It comes back every wet season until the drainage is corrected.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
In San Francisco, paver driveway installation runs $8,260 to $21,240, and concrete driveway installation runs $5,310 to $14,160. Driveway sealing, when the system is otherwise sound, runs $295 to $825 and is the inexpensive way to protect joints after a repair.
What drives the range: total square footage, whether the base needs full reconstruction or just spot repair, disposal of old material (uphill on a steep SF lot costs more), and whether an edge restraint or drainage correction is added. Our quotes are line-item and upfront, so you see the parts and labor split before we start. Work is covered by our 730-Day Done Right Promise: if it’s not done right, we make it right.
DIY or Call Us?
An owner can safely walk the drive, mark rocking pavers with chalk, photograph joint failures, and note where water pools. Those observations make the repair easier and faster.
What goes wrong with DIY is base work. Re-bedding a paver on sand without fixing compacted base underneath looks fine for one rainy season and then fails again. Lifting a section and re-laying it without matching joint width, edge restraint, and slope puts the drive back exactly where it started, just a season later. On a paver driveway, the base is the whole job. Call (866) 320-2646 and we’ll tell you honestly whether you need spot repair or a section rebuild.
FAQs
How long does a Moen paver driveway last in San Francisco? A Moen paver driveway installed over a properly compacted base typically lasts 25 to 30 years, but the joints and edge restraints need attention every 3 to 5 years in San Francisco’s wet, foggy climate. Poor base drainage is the single biggest cause of early failure. Call (866) 320-2646 for a free assessment.
Can the failed section be repaired instead of replaced? Yes. Isolated paver replacement, edge restraint repair, and joint re-sanding are common and far cheaper than a full rebuild, as long as the base underneath is intact. If more than roughly 20 percent of the drive is rocking, a section rebuild is usually the better money. Call (866) 320-2646 to get a line-item quote either way.
How long does the swap take? A single-paver replacement or joint reset takes under an hour; a section rebuild of a 200-square-foot area typically takes one to two days depending on base conditions. We schedule around weather so the base isn’t exposed. Call (866) 320-2646 for a scheduling window.
How do you source the correct Moen part for my driveway? We identify the paver profile from measurements and any visible stamp, then source OEM where the dimensional match to your existing run matters and aftermarket where it doesn’t. Every part is confirmed against your measurements before install. Call (866) 320-2646 to get the match started.
Call (866) 320-2646 to schedule your free estimate. Our phones are answered by a live person 24/7, and every visit is handled by a background-checked, uniformed technician who walks the drive with you before quoting.
Written by the team at Groundwork Construction Co. of San Francisco, serving San Francisco and nearby areas.