Windows & doors
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Therma-Tru Windows & Doors: The San Francisco Owner’s Guide
We install and replace Therma-Tru windows and doors across San Francisco, and most full replacements land between $5,310 and $17,700 depending on size, frame material and whether it’s a single unit or a multi-panel opening. Impact-rated units in San Francisco run higher, $9,440 to $29,500, because they have to carry the glass and frame certification the city expects. The part itself is usually the cheap piece; labor, disposal and permit handling are what shape the number. We keep estimates free and give you the figure in writing before anything gets ordered.
Most owners don’t call us about a “part” at all. They call because the door drags on the threshold in the Inner Sunset fog, or the sidelight glass fogs from the inside and won’t wipe clear, or the multipoint lock stopped catching and now the door won’t seal against wind. That’s the pattern: a Therma-Tru unit in a San Francisco Victorian or a Richmond District stucco box hits fifteen or twenty years and one small component gives out before the door or window frame does. You notice the symptom long before you know what to call it.
Which Therma-Tru Models This Applies To
Therma-Tru’s product lines don’t share parts the way a homeowner might assume. Their entry doors (the Fiber-Classic, Smooth-Star and Classic-Craft families) use different hinge prep, different sill geometry and different multipoint hardware than their patio door systems, and a lock or threshold from one line will not drop into another. Sidelight glass, astragals, sweeps and weatherstrip are all line-specific and often handed (left versus right swing matters). This is the first compatibility gotcha: two doors can look identical from the street and take completely different replacement parts.
To identify what you have, look for the Therma-Tru certification label on the hinge jamb or the top of the door slab, photograph it, and measure the rough opening and the slab itself. If the label is painted over or gone, the measurements plus a photo of the hinge and lock hardware usually settle it. On the OEM question: for hardware that carries a warranty or affects the latch, we source genuine Therma-Tru components, because aftermarket locks and multipoint gear on a Therma-Tru door tend to bind within a couple of seasons. For sweeps, weatherstrip and threshold caps, a quality aftermarket equivalent is often just as good and far cheaper, and we’ll tell you which is which. We’re an independent San Francisco service provider, not affiliated with Therma-Tru, so our recommendation follows the door, not the badge.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Therma-Tru Windows & Doors Is Failing
These are the symptoms we see most across San Francisco, and what’s usually behind each one:
- The door drags or rubs the threshold. The sill or the door slab has settled, or the adjustable threshold has worn through. Common in older homes where the frame has shifted; the door isn’t warped, the opening moved.
- Fogging between the glass panes. The sealed unit lost its argon fill and the desiccant is saturated. No amount of wiping fixes it; the insulated glass unit gets replaced, not the whole door.
- The multipoint lock won’t catch or the handle feels loose. The gear mechanism or the strike plates have worn or the door has dropped slightly on its hinges. Left alone, an unsealed door lets our coastal wind and moisture straight in.
- Daylight or a draft around the perimeter. Weatherstrip, sweep or the sill cap has flattened out. In San Francisco’s fog belt this is the failure that quietly raises your heating bill all winter.
- The threshold cap is cracked or the sweep is shredded. Foot traffic plus grit does this. It’s a small part but a big leak point, and it’s one of the few fixes an owner can inspect safely.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
For San Francisco, a straight window replacement runs $5,310 to $17,700 installed, and impact window installation runs $9,440 to $29,500. A full door replacement sits inside the same general band as the window replacement range, higher for wide multi-panel and sidelight configurations and higher again when the opening needs framing work. What moves the number: unit size, frame material, glass package, whether the rough opening is square, and whether you’re in a historic district that triggers extra review. Parts-plus-labor is broken out line by line, so you see what the component costs against what the install costs.
Every install is covered by our 730-Day Done Right Promise: if it’s not done right, we make it right. Pricing is upfront, with no surprises once the work starts, and there’s $1,000 off projects over $10,000 plus 0% financing for 18 months if the scope grows past a single unit. Permits are pulled and inspections passed where San Francisco requires them.
DIY or Call Us?
Some of this you can safely check yourself. You can photograph the label, measure the slab and rough opening, clean and lubricate hinges, and replace a torn sweep or worn weatherstrip. That’s the honest line. Where owners get into trouble is adjusting the threshold and hinge geometry to chase a drag, then finding the door no longer latches or seals square, or ordering a lock or insulated glass unit that doesn’t match their line and swing and can’t be returned. Nothing here is high-voltage dangerous, but a door that won’t seal in a San Francisco winter costs more to fix later than to get right the first time.
If you’re unsure which part you’re looking at, call us at (866) 320-2646. A live person answers around the clock, and we’ll help you identify it and price the fix.
FAQs
How long does a Therma-Tru door or window last in San Francisco? Most Therma-Tru units hold their structure for twenty to thirty years, but the wear parts (weatherstrip, sweeps, threshold caps, seals) typically need attention at the ten to fifteen year mark, and sooner on the foggy west side where moisture cycles constantly. The frame outlasts the hardware, so replacing components is usually the right call rather than the whole unit. Call (866) 320-2646 for an exact quote; estimates are free.
Can the part be repaired instead of replaced? Yes, more often than not. A fogged pane gets a new insulated glass unit, a dragging door gets a threshold and hinge adjustment, a worn sweep gets swapped. Full replacement only makes sense when the frame or slab itself is compromised. We’ll tell you which side of that line you’re on. Call (866) 320-2646 to schedule a free estimate.
How long does the swap take? A weatherstrip, sweep or threshold job is typically done in a single visit. An insulated glass unit swap usually takes one visit plus the glass lead time. A full door or window replacement is a scheduled job, and most single-unit installs are completed in one day. Call (866) 320-2646 and we’ll give you a realistic timeline for your specific unit.
How do you source the right Therma-Tru part? We match your line, swing and measurements from the label and photos, then order genuine Therma-Tru hardware where it matters and a quality aftermarket equivalent for the low-risk pieces, always with the choice explained up front. You get the written line-item quote before anything is ordered. Call (866) 320-2646 to start.
We also work with KraftMaid, Cambria and Silestone on the interior side of larger remodels, so if your window or door project is part of a bigger San Francisco renovation, one contractor can carry it from foundation to finish line.
Ready to price it? Call Groundwork Construction Co. of San Francisco at (866) 320-2646 for a free estimate. A live person answers 24/7, and we’ll confirm what part you need and what it costs before you commit to anything.
Written by the team at Groundwork Construction Co. of San Francisco, serving San Francisco and nearby areas.