Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
See the difference
Before
After
Before
After
Before
AfterWindow Installation in San Francisco, CA
Window installation in San Francisco typically runs $650 to $1,450 per opening for a standard vinyl or fiberglass unit, and $1,600 to $3,200 or more per opening for wood-clad or custom architecturally matched replacements in neighborhoods with historic design review. That range covers removal, new construction, flashing, trim, and haul-away on most homes. Groundwork Construction Co. of San Francisco installs through a curated set of verified brand partners, most jobs finish in a single visit, and every install is backed by our 730-Day Done Right Promise.
Replacing windows in this city is not a generic job. Fog belt humidity on the west side, salt air in the Sunset and Richmond, and the wind-driven rain that hits exposed facades near Twin Peaks and the Marina all punish windows that were spec’d for a drier climate. We install units that can take it, and we flash them the way this city’s weather requires. If you want the wider picture of what we handle across glass, frames, and doors, start with our Windows & Doors page. To get a free estimate, call us at (866) 320-2646.
Key Takeaways
- Typical San Francisco window replacement lands between $650 and $1,450 per standard opening; wood-clad and custom units cost more.
- Most single-window and small-batch installs are completed in one visit.
- Coastal and fog-belt homes need correctly flashed and insulated units or they fail early.
- Every install is covered by the 730-Day Done Right Promise, with upfront pricing and a free design consult.
- Windows answer a real question here: drafty single-pane units in pre-1950 housing drive up heating bills and leak.
When You Need Window Installation
Windows fail slowly and then all at once. Here are the situations that most often send San Francisco homeowners calling us, and each one is something we see constantly in this housing stock.
- Your single-pane windows are fogging between the glass. Once the seal on an insulated unit breaks, moisture gets in and you get that cloudy film you can’t wipe off. It’s common in mid-century units across the Sunset and Richmond, and the fix is replacement, not cleaning.
- You feel drafts and the frame is cold to the touch. In pre-1940 houses with original double-hung windows, worn weatherstripping and settled frames let the fog creep in. If you’re running the heat more each winter, the glass and seals are often the culprit.
- The windows won’t open, close, or stay up. Painted-shut sashes and failing balances are routine in older Victorians and Edwardians. If a window is stuck or won’t hold, that’s often a sign the whole unit is past its life.
- You’re remodeling and the schedule depends on new openings. A kitchen or addition project needs windows ordered against exact rough openings. We coordinate glass and frames with the rest of the build so nothing sits waiting on a delivery.
- Water is staining the interior trim or sill. Rot around a window frame means water has been getting behind the flashing. In fog-belt neighborhoods this can spread into the wall before you notice. Replacement plus correct flashing stops it.
- Noise from the street keeps you up. Homes on busy corridors and near BART and Muni lines benefit from laminated or dual-pane glass that cuts sound as well as heat loss. It’s one of the more underrated reasons people replace windows here.
Our Window Installation Process
We keep the process predictable because window projects go sideways when nobody plans the details. Here’s how a Groundwork install runs from first call to final walkthrough on a San Francisco home.
- Walkthrough and measure. We come out, measure every opening, and look at how the existing windows are flashed and framed. On older homes we check for settled framing and hidden rot so the estimate reflects what we’ll actually find. You get upfront pricing, no surprises.
- Brand and material selection. We walk you through the curated brands we install so you’re choosing quality, not just what’s in stock. For homes with design-review or historic considerations, we match profiles and muntins to keep the look intact. That design consult is free.
- Order and scheduling. We place the order against confirmed measurements and give you a realistic install date. Weather matters in this city, so we schedule around the forecast rather than fighting it.
- Install day. Background-checked, uniformed technicians arrive on time, protect your floors and furniture, and remove the old units. We set the new window, flash and seal it correctly for this climate, insulate the gap, and reinstall trim. Most installs finish in a single visit.
- Seal, test, and clean up. Every window gets opened, closed, and locked to confirm it works. We check the seals, clean the glass, and haul the old units away. You’re not left with a pile of debris.
- Final walkthrough and the promise. We walk the job with you, show you how to operate and care for the windows, and hand over the written 730-Day Done Right Promise. If anything isn’t right, we make it right.
Calls are answered by a live person, 24/7, so if a question comes up before, during, or after install, you reach someone. And because windows often pair with other exterior work, we handle the full scope from foundation to finish line. If you’re also looking at a broader exterior refresh, our home page shows the seven service lines we run.
Window Installation Pricing in San Francisco
Window pricing in San Francisco is driven by unit type, glass package, and how much framing and trim work the opening needs. City labor rates and the age of the housing stock both push costs up compared with cheaper markets. Here’s an honest breakdown of what homeowners typically see.
| Window Type | Typical Installed Range (per opening) |
|---|---|
| Standard vinyl single-hung or slider | $650 – $1,050 |
| Fiberglass or vinyl with upgraded glass | $950 – $1,450 |
| Wood-clad replacement (e.g., Andersen, Pella) | $1,400 – $2,400 |
| Custom or historic-matched wood | $2,000 – $3,200+ |
| Large picture or specialty windows | Priced per opening after measure |
What moves the number:
- Glass package. Dual-pane, low-E, and laminated sound-reduction glass each add cost but pay back in comfort and lower heat loss.
- Frame material. Vinyl is the value option; wood-clad and custom wood cost more but preserve the look of older homes.
- Framing and rot repair. If we open a wall and find rot behind the flashing, that repair is built into the scope rather than discovered later.
- Access and height. Upper-floor windows, steep lots, and tight city access take more care and time, which affects labor.
- Design review. Homes in historic districts may need profiles that match the original, which can mean custom units.
We quote upfront pricing so the number you see is the number you pay. On larger window projects, $1,000 off projects over $10,000 and 0% financing for 18 months help spread the cost. For window work that runs under $10,000, our free estimate and design consult is where every project starts.
FAQs – Window Installation
How much does window installation cost in San Francisco?
Window installation in San Francisco ranges from about $650 to $1,450 per standard opening, with wood-clad and custom units running $1,400 to $3,200 or more depending on glass, frame material, and any rot repair. The wide spread reflects how different the housing stock is across the city, from a mid-century Sunset home to a Victorian in the Mission. Call (866) 320-2646 for an exact quote on your openings, and estimates are free.
Can you install windows in a single visit?
Yes, most individual window and small-batch installs are completed in one visit. Our background-checked, uniformed technicians arrive with the units ready, remove the old windows, set and flash the new ones, and clean up before they leave. Larger whole-house jobs or openings that need new framing span multiple days, and we’ll tell you the schedule upfront.
Do I need special windows for a historic or design-review home?
Often yes. Homes in San Francisco’s historic districts and many pre-1950 neighborhoods require window profiles and muntins that match the original look, which can mean custom wood units rather than standard vinyl. We help you choose a match that satisfies the design while improving performance. Call (866) 320-2646 and we’ll walk your specific block and building through the options.
Is it cheaper to repair or replace my windows?
Repair wins when the problem is one worn balance or a single failed seal. Replacement wins once multiple units are drafty, fogged, or rotting at the frame, because patching them adds up fast and never fixes the underlying seal. In fog-belt homes, repeated repairs on the same windows usually signal it’s time to replace. Call (866) 320-2646 for a straight answer on your situation, and the estimate is free.
Groundwork Construction Co. of San Francisco installs windows built for this city’s salt air, fog, and wind-driven rain, backed by the 730-Day Done Right Promise and the premium brands we stand behind, including Andersen, Pella, and James Hardie for the exterior detailing around each opening. Our technicians bring up to 12 years of experience, and every install gets careful flashing, proper insulation, and a clean final walkthrough. Calls are answered by a live person around the clock, and pricing is upfront with no surprises.
Whether you’re replacing a handful of fogged units in the Sunset or re-glazing a whole Victorian, the next step is simple: call (866) 320-2646 for a free estimate. You’ll get real numbers, a clear schedule, and a team that answers the phone whenever you call.
Written by the team at Groundwork Construction Co. of San Francisco, serving San Francisco.