Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Small & Partial Kitchen Remodels in Tamalpais-Homestead Valley, CA
Small and partial kitchen remodels in Tamalpais-Homestead Valley typically run $14,000 to $45,000, with the lean end covering a cabinet refacing and countertop swap and the high end covering new cabinets, layout tweaks, and relocated plumbing or electrical. Most take three to six weeks of active work once permits clear. The Homes under redwood canopy on the north-facing slopes usually add a week of prep because moisture, rot, and old rough-in work surface before anything new goes in. Call (866) 320-2646 for a free on-site estimate.
How we run a partial kitchen job here, stage by stage
Small & partial kitchen remodels are not full gut jobs, but they follow a real sequence. The trick is knowing what stops work and what doesn’t before the first hammer swings.
Stage 1: Walkthrough and scope lock (day 1)
We open cabinet doors, pull one drawer, check under the sink for old leaks, and photograph the panel and any gas shutoffs. You tell us what stays and what goes. By the end of the visit you have a written line-item scope. If our technicians suspect termites, rotted subfloor, or a water heater in the way, we say so now – not on day four.
Stage 2: Permits and ordering (days 2 – 7)
Most partial kitchens that touch plumbing, electrical, or a load-bearing wall need a County of Marin building permit, not a city one. We pull it and lock the inspection schedule. Meanwhile you finalize cabinet finish, countertop slab, and appliance models. Cabinet lead time is the biggest wild card – KraftMaid and Wellborn custom lines run four to seven weeks, stock finishes drop to two.
Stage 3: Demo and prep (days 8 – 10)
We remove only what’s scheduled, protect the floors and adjoining rooms, and shut off the kitchen water. This is where surprises live in Tamalpais-Homestead Valley: damp framing under a bay window, a drain line that’s been patched twice, a floor that’s out of level by an inch. You’ll get a call with photos and a set price for any added repair before we touch it.
Stage 4: Rough-in and set (days 11 – 22)
Plumbing, electrical, and any framing changes go in first, then the rough inspection. Cabinets set, countertops template and install, backsplash, sink, and fixtures. Two to three trades are on site most days but not all at once, so the room stays usable until counter installation.
Stage 5: Punch list and walkthrough (days 23 – 30)
We test every drawer, run both faucets hot and cold, check the dishwasher connection, and walk the room with you. Anything on the list gets fixed before we call it done, and the 730-Day Done Right Promise covers the workmanship in writing.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The choices that actually decide your kitchen
Options on a partial remodel come down to five decisions. Each one carries a trade-off, not a “best” answer.
- Cabinet doors vs. full replacement. Refacing keeps the boxes and replaces doors, fronts, and veneer – often a third of the cost and holds up for 15 – 20 years if the boxes are solid. Full replacement costs more and buys you adjustable shelving, soft-close everywhere, and a cleaner interior.
- Laminate vs. quartz counters. Laminate is the budget pick with shorter life and visible seams. Quartz and Cambria give you a harder surface that resists redwood-pollen staining and damp-side swelling, at roughly double the material cost.
- Tiled backsplash vs. slab. A tile run is the practical choice for most partials. A slab backsplash is a clean look but adds slab waste and a higher install price.
- Sink and faucet swap. A drop-in sink works with an existing counter cutout. An undermount sink almost always means new counter, so plan them together.
- Lighting. Adding under-cabinet LED and swapping two recessed cans is a cheap transformation. Moving switches or adding circuits to a packed panel is where cost climbs.
What Small & Partial Kitchen Remodels cost in Tamalpais-Homestead Valley, CA
Plan on $14,000 to $45,000. Where you land in that band depends on four things:
- Size and scope. A galley kitchen with cabinet refacing and a counter swap sits at the low end. An L-shaped kitchen with full cabinet replacement, new island, and a moved range sits near the top.
- Existing condition. Dampness, rot, and out-of-level floors common to hillside redwood-shaded homes push the number up. A dry, recently updated kitchen stays lean.
- Relocating services. Keeping plumbing and electrical in place is the cheapest decision you can make. Moving the sink or range adds trade work, permits, and inspection time.
- Material grade. Stock cabinet lines and laminate counters versus custom finishes and quartz. The gap between the two ends of the range is often just material choices.
- Permit scope. Cosmetic-only work may not need a permit. Anything touching plumbing, electrical, or structure does, and review time on hillside lots in Marin adds scheduling days.
Every written estimate is line-itemed: labor, materials, permit fees, and disposal. No change orders once work starts unless you approve them. What’s typically not included: appliance purchases, structural repair discovered after demo, and any work on the deck or exterior.
See the difference
Before
After
Before
After
Before
AfterWhat Tamalpais-Homestead Valley homes specifically do to this job
This unincorporated community of steep, wooded hillside lots sits under County of Marin permitting, not city. That changes the process: plans go to Marin County, and inspection scheduling runs on their calendar, not ours. On the narrow, winding private lanes off the valley floor, truck access and staging are real constraints. A dumpster may need a permit and a spot at the driveway mouth because there’s nowhere else to put it. Homes built as mid-century redwood-and-glass or 1950s – 70s post-and-beam often have original wiring, low-amperage panels, and framing that’s been altered over decades. North-facing homes under redwood canopy stay damp, so we check for soft flooring, moss on exterior walls, and rot under window sills before we spec new countertops. A full scope of related work is available through Kitchen Remodeling in Tamalpais-Homestead Valley when a partial turns out to be a full.
Serving Tamalpais-Homestead Valley, CA – Our Local Coverage Area
We serve Tamalpais-Homestead Valley and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked – Small & Partial Kitchen Remodels in Tamalpais-Homestead Valley
Plan on three to six weeks of active work. The biggest variables are cabinet lead time (four to seven weeks on custom lines) and County of Marin permit review. Call (866) 320-2646 for a realistic timeline specific to your kitchen.
Yes, if the work touches plumbing, electrical, or structure – which is most jobs that move a sink, add a circuit, or change a wall. Cosmetic-only swaps like refacing and counter replacement often don’t need one. We pull the permit for you and schedule the inspections.
Yes, and it’s the smartest way to control cost. Keeping the sink, range, and walls in place cuts trade work and often skips a permit. You still get new cabinets, counters, backsplash, and lighting in the same footprint.
Most run $14,000 to $45,000. A refacing and countertop package lands near the low end; full cabinet replacement and moved services push toward the high end. Call (866) 320-2646 for an exact quote – estimates are free.
Every job is covered by the 730-Day Done Right Promise. If a door hangs wrong, a seam opens, or a faucet leaks from installation, we come back and make it right for two years. The guarantee is in writing before we start.
Get a free estimate for your Tamalpais-Homestead Valley kitchen
We’ll walk your kitchen, measure the space, and hand you a line-itemed scope with a fixed price – the number you see is the number you pay. That’s the free project estimate and design consult. If your project runs over $10,000, $1,000 off applies, and 0% financing for 18 months is available. Call (866) 320-2646 – a live person answers around the clock. Homeowners often pair this job with a full kitchen remodeling scope or with Small Bathroom Remodels in Tamalpais-Homestead Valley while the trades are on site, and Roof Repair in Tamalpais-Homestead Valley if the rainy season has found a way in. We cover all of Tamalpais-Homestead Valley and the surrounding canyon roads.
Written by the team at Groundwork Construction Co.