Home additions & ADU
Kitchen remodeling
Bathroom remodeling
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Vanities, Tile & Fixtures in Tamalpais-Homestead Valley, CA: What It Really Takes
Vanities, tile and fixtures in Tamalpais-Homestead Valley typically runs $9,000 to $28,000 for a full gut-and-replace of a primary bath, and most of that work happens across 2 to 4 weeks on site. The number swings mostly on tile selection, whether the vanity moves, and how much old tile and mortar has to come off first. For an exact figure on your house, call (866) 320-2646 and we’ll walk it with you on site.
Here’s the part nobody says out loud: in a valley where homes sit under coast redwoods on the north-facing slopes, the failure you find behind a tile wall is rarely the tile. It’s moisture that’s been getting in for years. That changes what fixtures and finishes make sense.
Key Takeaways
- A vanity, tile and fixture package in Tamalpais-Homestead Valley runs $9,000 – $28,000.
- Demo and prep are usually 2 – 4 days and reveal most of the surprises.
- Tile is the single biggest cost variable – porcelain vs. natural stone can swing thousands.
- County of Marin (not city) permitting applies here; pulling it correctly is part of the job.
- Everything’s backed by our 730-Day Done Right Promise.
How We Sequence Vanities, Tile & Fixtures, Day by Day
Every stage has a decision deadline, and the homeowner owns a few of them. Here’s the real order.
Stage 1 – Site measure and material lock (1 – 3 days before demo)
We measure the room, confirm drain and supply locations, and set the vanity footprint. You pick the vanity cabinet and countertop at this stage, because lead times on a made-to-order vanity run 2 to 6 weeks and the demo shouldn’t start until the cabinet’s on order. This is also when you choose tile. Wait until next week to order and the job stalls.
Stage 2 – Protection and demolition (1 – 2 days)
We mask the halls, cover floors, and tear out the old vanity, tile, backer board, and any failing subfloor. Old tile mortar is heavy and slow; a small bath is a day, a full bath can be two. This is the day we find out whether the subfloor is soft and whether the framing behind the tub survived.
Stage 3 – Plumbing rough-in, subfloor repair, waterproofing (2 – 4 days)
If the vanity is moving or the shower valve is being replaced, plumbing rough-in happens now. Subfloor repair – new plywood, leveling compound – goes in before anything else. Then the waterproofing membrane goes on the walls and pan. That membrane is the difference between a bathroom that lasts 30 years and one that fails in five, and you don’t get to see it once the tile’s up, so we document it with photos.
Stage 4 – Tile setting, grout, and cure (4 – 7 days)
Tile goes up on the walls, down on the floor, with grout after cure. Natural stone needs sealing before and after grout. Porcelain doesn’t need sealing at all. Layout matters – we set the pattern with you on a dry-lay board before we commit to the wall.
Stage 5 – Vanity set, fixtures, and final walkthrough (2 – 3 days)
The vanity and countertop are set, the faucet, shower trim, and toilet are installed, and we do a full water test on every connection. You walk the room with us, note anything that bugs you, and we fix it before we hand over the keys.
If this vanity and tile package is one piece of a bigger project – a whole floor or a second bath – it works best coordinated inside our Bathroom Remodeling service so the trades and the schedule move together.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Choices You’ll Actually Make – and What They Cost You
Most of the swing in a vanities, tile and fixtures project is in three decisions: the vanity, the tile, and the fixtures. Here’s the honest version of each.
- Vanity cabinet: A stock MDF vanity with a painted finish runs $800 to $1,800. A semi-custom cabinet jumps to $2,000 to $3,500. Solid wood or a premium brand like KraftMaid sits at the top. Stock is fine in a powder room you use twice a week; the primary bath is where a better cabinet earns its keep.
- Countertop: Laminate is the budget call and doesn’t belong next to a stone tile floor. Quartz or a Cambria surface holds up to water and soap scum far better. Marble is beautiful and stains if you’re not careful. Expect $400 to $1,200 for a typical 48-inch vanity top.
- Floor and wall tile: Porcelain is the workhorse – hard, waterproof, no sealing, $4 to $12 per square foot installed. Natural stone (travertine, slate, marble) is $10 to $25 per square foot installed and needs sealing every year or two. Redwood-shaded rooms hold moisture longer, so sealing schedules matter more on the valley’s north-facing slopes.
- Shower and tub fixtures: A basic chrome pressure-balance valve and trim runs $150 to $350. A thermostatic or branded Kohler set runs $400 to $900. The valve behind the wall is invisible but it’s the part you’ll regret cheaping out on.
- Faucets and accessories: $80 to $400 per faucet. Towel bars, a mirror, and a medicine cabinet add $200 to $800. Small line item, but it’s what you see every morning.
- Lighting and vent: A proper exhaust fan is $150 to $400 installed and it’s the single best defense against mold in a damp Marin bathroom. Don’t skip it.
What Vanities, Tile & Fixtures Cost in Tamalpais-Homestead Valley, CA
The line-item range in Tamalpais-Homestead Valley is $9,000 to $28,000 for a full bath package. Here’s how that splits.
| Line Item | Typical Range |
|---|---|
| Demo, protection, haul-away | $600 – $1,500 |
| Subfloor and waterproofing repair | $800 – $3,000 |
| Vanity cabinet + countertop + install | $800 – $3,000 |
| Floor and wall tile (labor + material) | $2,500 – $8,000 |
| Shower/tub fixtures and trim | $400 – $1,800 |
| Faucets, lighting, vent fan, accessories | $400 – $2,200 |
| Plumbing and electrical updates (if needed) | $800 – $4,500 |
| Permit and inspection | $300 – $1,200 |
Four things push a job to the high end. First, size: a 35-square-foot powder room and a 90-square-foot primary bath aren’t the same job even with identical finishes. Second, what’s behind the wall – rot, a soft subfloor, or furring that has to be rebuilt all cost money you can’t see until demo. Third, relocating the vanity or shower drain means moving plumbing, which means opening the floor. Fourth, material grade: natural stone tile and a thermostatic valve set can add $6,000 to $10,000 on their own. A written line-item estimate from us separates labor from material for every line and holds to the number; you won’t get a change order for a tile we already priced. Call (866) 320-2646 and we’ll put it on paper. If you want the broader remodel scope outlined too, see our Bathroom Remodeling in Tamalpais-Homestead Valley page and we’ll coordinate the two.
See the difference
Before
After
Before
After
Before
AfterWhat Tamalpais-Homestead Valley Homes Do to This Job
This is unincorporated Marin County, which means County permitting rather than a city building department – and that changes the inspection timeline and the paperwork trail. Homes on the north-facing, redwood-shaded slopes stay damp almost year-round, so we plan for a longer cure on grout and thinset, and we spec better exhaust than we’d use on the sunny side of the valley. The housing stock here is largely mid-century redwood-and-glass hillside homes and 1950s-70s post-and-beam construction, so the tile we take off is often original to the build and the subfloor beneath it is 70 years old. On the narrow winding lanes around Homestead Valley, staging matters too: deliveries for a 2,000-pound countertop need to park within reach, so we plan the tile and vanity drop before demo day. If you’re adding waterproofing or deck work nearby, homeowners often pair this with Tile Roofing in Tamalpais-Homestead Valley and Specialty Roofing in Tamalpais-Homestead Valley to handle the moisture from the top down. Our background-checked, uniformed techs handle all of it, and if you’re in the 94941 ZIP, we’ve worked this terrain. See the wider Tamalpais-Homestead Valley service area for how we cover the valley.
Serving Tamalpais-Homestead Valley, CA – Our Local Coverage Area
We serve Tamalpais-Homestead Valley and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Vanities, Tile & Fixtures in Tamalpais-Homestead Valley
Most of the time it’s 2 to 4 weeks of on-site work and 4 to 8 weeks of calendar time once you factor in vanity and tile lead times. Powder rooms finish closer to 2 weeks; a full primary bath is 4. Call (866) 320-2646 and we’ll give you a real date range on your specific room.
Cosmetic tile and vanity replacement usually doesn’t need a permit. Moving plumbing, adding an exhaust fan with new ducting, or changing the shower footprint does, and because this is unincorporated Marin County, the permit runs through the County. We pull it and pass the inspection as part of the job. Estimates are free – call (866) 320-2646.
Yes, and it’s a meaningful cost saver. Keeping the vanity and drain in place means no plumbing rough-in and no floor opening, which can shave $1,500 to $4,000 off the job. We confirm the old drain and supply lines are sound before we commit. Call for a free estimate.
The full range is $9,000 to $28,000. A powder room at the low end and a full primary bath with a stone tile floor, semi-custom vanity, and thermostatic fixtures at the top. We quote every line in writing and the number you see is the number you pay. Call (866) 320-2646 for an exact quote – estimates are free.
Every vanities, tile and fixtures project we do is backed by the 730-Day Done Right Promise: if it isn’t done right, we make it right. That covers workmanship on tile setting, waterproofing, and installation. Call (866) 320-2646 and we’ll walk you through what’s covered.
Get a Free Estimate on Vanities, Tile & Fixtures in Tamalpais-Homestead Valley
We’ll come out, measure the room, look at what’s behind the old tile, and put a line-item estimate in your hands. No pressure, no vague lump sums. Financing is available at 0% for 18 months, and projects over $10,000 take $1,000 off. A live person answers (866) 320-2646 any hour, any day. Call today and we’ll book your free on-site estimate.
Written by the team at Groundwork Construction Co.