Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Walk-In Showers & Shower Remodeling in San Anselmo: What It Takes and What It Costs
Walk-In Showers & Shower Remodeling in San Anselmo typically runs $4,500 – $12,000 for a straight walk-in installation and $9,000 – $28,000 when the job pulls in the wider bathroom scope, and most projects finish in two to four weeks once permits clear. The work includes demolition of the old pan and surround, waterproofing, tile or panel finish, glass, drain and valve rough-in, and inspection. Call (866) 320-2646 to schedule a free estimate.
How Our Walk-In Shower Process Runs, Stage by Stage
Shower work is unforgiving. Almost all of the value is buried behind the tile, so we sequence it carefully and we don’t rush the layers that nobody sees again.
Stage 1: On-site measure and design consult (week one)
We measure the actual footprint, check the subfloor and framing, confirm drain location and slope, and look at what the wall behind the old surround is made of. This is where you decide curb vs. curbless, the glass configuration, and whether the valve stays put or moves. On San Anselmo flats homes, this is also where we flag any framing that won’t take a glass panel load cleanly.
Stage 2: Permits and material selections (one to three weeks, runs in parallel)
We pull the permit and lock your selections: tile, waterproofing system, drain type, valve trim, and glass. Tile lead times are the usual bottleneck, so we order before demo starts, not after. You’ll sign off on a written line-item scope here, and the number you see is the number you pay.
Stage 3: Demolition and rough-in (days one to three)
Out comes the old pan, surround, and any rotting drywall or greenboard. We inspect framing and subfloor, sister or replace as needed, and rough in the drain, valve, and any relocated supply lines. If we find framing damage or an undersized drain line, that’s a conversation before we close anything up.
Stage 4: Waterproofing, inspections, and tile (days four through ten)
This is the stage that decides whether the shower lasts. We install the waterproofing membrane, flood-test where required, pass inspection, then set tile, grout, and seal. Curbless jobs take the longest here because the slope and linear drain work have almost no tolerance for error.
Stage 5: Glass, fixture trim, and final walkthrough (days eleven through fourteen)
Glass is templated after tile cures and installed last. We set trim, test the valve and drain, clean up, and walk you through it. If something isn’t right, the 730-Day Done Right Promise means we come back and make it right, in writing.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Actually Choose Between
Most of the decisions that change your price and your daily experience get made in the first two weeks. Here’s the honest version of each.
- Curb vs. curbless: A curbless entry looks cleaner and is easier to age into, but it adds $1,500 – $3,000 because the floor has to be recessed and the linear drain set precisely. A low curb costs less and drains reliably on a standard subfloor.
- Tile vs. solid-surface panels: Porcelain and ceramic tile gives you the widest range of looks and holds up for decades, at $15 – $40 per square foot installed. Acrylic and solid-surface panels go in faster and cost less up front, but show scratches and have a shorter lifespan.
- Waterproofing system: A bonded sheet membrane or a liquid-applied system both work when installed correctly. We specify one rated for a wet area and stick with it; the cheap shortcut here is what causes the leak call in year three.
- Glass: Frameless glass looks best and costs more; a framed or semi-framed enclosure saves $400 – $1,200. Either way, glass is templated after tile.
- Fixtures: Kohler and similar brands are what we install most. A thermostatic valve is worth the upgrade if you’ve ever been scalded by a toilet flush.
- Niches and bench: A recessed niche runs $150 – $400; a built-in bench adds $500 – $1,200 and gives you a place to sit and a place to shave a leg.
What Walk-In Showers & Shower Remodeling Costs in San Anselmo, CA
For a standalone walk-in installation, expect $4,500 – $12,000. When the shower is one part of the wider bathroom work, the full Walk-In Showers & Shower Remodeling range in San Anselmo lands at $9,000 – $28,000. These numbers assume a standard footprint and normal access.
Five things push a job toward the top of that range:
- Size and layout: A four-foot alcove shower is far cheaper than a five-by-six walk-in with a linear drain.
- Existing condition: Rotted subfloor or framing from a long-running leak adds demo and carpentry time.
- Moving plumbing or electrical: Relocating the drain or valve, or adding a light and fan, adds $600 – $2,500.
- Material grade: Large-format porcelain and a frameless enclosure sit at the high end; standard tile and a semi-framed door at the low end.
- Permit scope: A straight replacement may not need one; a reconfiguration with new plumbing usually does, and inspection adds time and a fee.
A written estimate should list demolition, framing repair allowance, waterproofing, tile, glass, fixtures, and permit. It typically excludes major structural repair discovered mid-demo, which we quote before proceeding.
See the difference
Before
After
Before
After
Before
AfterWhat San Anselmo Homes Specifically Do to This Job
The housing stock here drives the work. Much of San Anselmo’s flat-lot core is early-1900s to 1950s Craftsman and bungalow, and the bathrooms in those homes were often added or patched decades later. That means we routinely open a wall and find knob-and-tube-era wiring next to a 1990s valve, or a subfloor that’s been quietly flexing under a cast-iron drain. Along Sir Francis Drake Boulevard and the streets off it, we plan a repair allowance into the estimate before demo, because the surprise is what blows a shower budget.
The bigger local factor is the creek. San Anselmo sits in the San Anselmo Creek watershed at the foot of Mount Tamalpais, and the downtown flat floods repeatedly, including the 1982 and 2005 storms. Any work that touches framing, foundation, or drainage near the creek can trigger county floodplain review before we start. In a shower remodel that usually shows up as moisture management: we specify drainage and vapor control carefully, because a bathroom on a flood-prone flat needs to dry out right. Homes climbing toward Sleepy Hollow and the Ross border sit on hillside foundations, where a shower’s weight and drain slope need more planning. If we’re covering a home across San Anselmo, we scope the shower as part of your Bathroom Remodeling in San Anselmo, and we use materials like James Hardie backer and KraftMaid cabinetry when the job widens out. This is one piece of our Bathroom Remodeling work, and homeowners often pair this with Roof Replacement & Installation in San Anselmo when a leak has come down through a ceiling, or with Metal Roofing in San Anselmo on the wooded slopes.
Serving San Anselmo, CA – Our Local Coverage Area
We serve San Anselmo and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Walk-In Showers & Shower Remodeling in San Anselmo
Most walk-in showers in San Anselmo take two to four weeks from the first day of demo to the final walkthrough, with tile and glass lead times adding the most variance. A simple alcove replacement can finish inside two weeks; a curbless job with a linear drain usually runs closer to four.
A straight fixture swap often doesn’t require a permit, but any reconfiguration that moves plumbing, changes framing, or relocates the drain does, and the town inspects that work. We pull the permit and handle the inspection, and we don’t start demo until it’s in hand.
Yes, and that’s the most common approach, keeping the existing drain and valve location and replacing everything around them. This is also the lowest-cost route, and it’s where a written estimate saves you guessing about what’s included.
Expect $4,500 – $12,000 for a standalone walk-in installation and $9,000 – $28,000 when the shower is part of the wider bathroom scope. Material grade, footprint, and any plumbing relocation are the big levers. Call (866) 320-2646 for an exact number, estimates are free.
Every walk-in shower we build is covered by the 730-Day Done Right Promise: if it isn’t done right, we make it right. That covers workmanship for two full years, one of the longest guarantees in the residential construction space, alongside manufacturer warranties on tile, fixtures, and glass.
Get a Free Estimate for Your San Anselmo Walk-In Shower
Call (866) 320-2646 and a live person answers, day or night. We’ll schedule a free on-site estimate, measure the space, talk through curbless versus curb, tile versus panel, and hand you a written, line-item quote before you commit. Your calls are answered 24/7, our technicians are background-checked and arrive in uniform, and we offer 0% financing for 18 months plus $1,000 off projects over $10,000.
Written by the team at Groundwork Construction Co.