Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Door Installation in Daly City, CA: What It Takes and What It Costs
Door installation in Daly City runs $650 to $3,200 for a standard exterior or interior door, with most single-door swaps landing between $900 and $1,800 and full entry-system replacements with sidelights climbing past $3,000. A straightforward interior door takes four to six hours; an exterior entry door with rot repair and trim work usually takes a full day plus a return visit for paint and final hardware. Call (866) 320-2646 and we’ll walk you through what your specific door opening needs before anyone swings a hammer.
The Five Stages of a Door Installation Job, Start to Finish
Every door we install follows the same sequence, and knowing it upfront is half the battle for a homeowner who’s been burned by vague timelines before.
Stage 1: Measure and Rough Opening Assessment (Day 1, 45-90 minutes)
This is where the real work begins. We pull the existing door, check the rough opening for square and plumb, and look for rot in the framing, sill, and header. On Daly City’s post-war stock, a fair share of openings reveal soft wood at the sill from decades of fog-driven moisture. You’ll decide here whether we repair framing or proceed as-is, and whether to resize the opening.
Stage 2: Demo and Prep (2-4 hours)
Old door out, trim off, threshold removed, and any rotted framing cut back and replaced with pressure-treated stock. We seal the rough opening against moisture before the new unit goes in, which matters more on a fog-soaked slope off Mission or Westlake than it would five miles inland. You confirm the door swing and handedness before we commit.
Stage 3: Dry Fit and Frame (2-3 hours)
The new door goes in dry, shimmed, and checked for square, plumb, and reveal uniformity. We test the swing, the latch, and the deadbolt alignment before any fasteners get set. This is the stage where a cheap door and a good door look exactly the same, and where we find out whether the wall itself is straight.
Stage 4: Fasten, Insulate, Weatherseal (2-3 hours)
Fasteners set, low-expansion foam injected around the frame, weatherstripping and threshold sealed against wind-driven rain. We flash the exterior head and jambs properly since Daly City’s wind-driven storms punish any gap. This is also where hardware gets mounted, knob, deadbolt, and closer if it’s a screen or storm unit.
Stage 5: Trim, Paint-Ready Finish, Final Walkthrough (half day, plus a return if painting)
Interior and exterior casing installed, caulked, and finished to paint-ready. We walk you through the operation of the door, the latch, the deadbolt, and the weatherseal, and hand off. Painting is typically a separate booking or a return visit once caulk has cured. Every job is covered by our 730-Day Done Right Promise, written into the contract.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Door Options You’ll Actually Choose Between
This is where homeowners spend the most decision time, and where it pays to know the trade-offs before you’re standing in a showroom.
- Fiberglass entry doors: Best all-around choice for Daly City’s coastal exposure. Doesn’t warp, dent, or rot, holds paint far longer than wood in fog, and comes in realistic wood grains. Runs $400-$1,200 for the slab, plus hardware and install.
- Steel entry doors: The budget pick and the security pick. Won’t crack like fiberglass, but dents under impact and can rust at the seams if the finish is compromised by wind-driven rain. Slab cost $250-$800.
- Solid wood entry doors: Beautiful and heavy, and the honest trade-off is maintenance. In your fog, expect to refinish every 3-5 years or the sun-facing stiles will check and split. Slab cost $800-$3,000.
- Interior doors: Hollow-core for closets and low-traffic rooms ($80-$200), solid-core for bedrooms and baths ($180-$500) if you want quiet and weight. Pre-hung units install faster and cleaner than slab-on-frame.
- Hardware grade: Builder-grade knob sets wear in five years on a busy entry. Upgrade to a Grade 1 or Grade 2 deadbolt and handle combo for $100-$300 more and it’ll outlast the door. Choose brands the way you’d choose a James Hardie or KraftMaid product, by the guarantee behind them, not just the look.
What Door Installation Costs in Daly City, CA
Most single-door installations run $650-$3,200. A simple interior swap lands at the low end. A front entry with rot repair, sidelights, upgraded hardware, and paint-ready finish pushes toward $3,200 or beyond. Here’s the line-item breakdown we put in writing.
- Interior door replacement (pre-hung): $250-$600 per door
- Exterior entry door (single, standard): $900-$1,800
- Entry with sidelights or transom: $1,800-$3,200
- Rot repair at sill or framing: $300-$900
- Resizing the rough opening: $500-$1,400
- Hardware upgrade (Grade 1 deadbolt set): $100-$300
- Interior/exterior trim and casing: $150-$500
What moves the price to the high end: relocating the opening, structural changes, matching a period door profile, or finding hidden rot after demo. What keeps it low: same-size swap, stock door, existing frame in good shape. What’s included in our written quote: door, hardware, standard trim, install labor, disposal, and caulk. What typically isn’t: paint finish (quoted separately), permit fees if required, or structural repairs uncovered after the wall is open. That number you see is the number you pay, no change orders for what we missed.
See the difference
Before
After
Before
After
Before
AfterWhat Daly City’s Housing Stock Means for Your Door
Daly City is a city of 1940s-1960s stucco-over-wood-frame homes on steep, fog-soaked slopes, and that fact drives almost every door decision we make here. On the streets off Mission and Westlake, contractors routinely pull an original door and find the sill, header, or rough framing quietly rotted from decades of coastal moisture, especially on the downhill side of the house where the wall stays damp. The fix isn’t optional: an entry door installed over soft framing leaks, sticks, and fails within two years.
Wind-driven rain is the second factor. Any door we install in Daly City gets extra attention to head flashing and threshold sealing, because the same storms that fail exterior paint here find every gap a cheap install left behind. And on the many homes with tuck-under garages or unpermitted additions quietly aging in the fog, we sometimes find the door opening is a door opening in name only, needing to be reframed and, where the underlying structure was never signed off, legalized before final inspection passes. Older homes in ZIP codes 94014, 94015, 94016, and 94017 often come with original single-pane sidelights attached to the entry, which we can preserve or replace as part of the same job.
Serving Daly City, CA – Our Local Coverage Area
We serve Daly City and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions About Door Installation in Daly City
A standard interior door takes four to six hours. An exterior entry with rot repair and trim takes a full day, plus a return visit for paint once caulk cures. Call (866) 320-2646 for a free estimate that includes the timeline for your specific opening.
Like-for-like door replacement typically doesn’t require a building permit. Resizing the rough opening, adding a new exterior door to the wall, or structural changes nearly always do. We confirm this before work begins and pull any required permits ourselves.
Yes, in most cases. A same-size replacement uses the existing rough opening and doesn’t touch plumbing or electrical. Resizing the opening can affect an adjacent switch, outlet, or light fixture, and we flag that in the estimate so you can decide before demo.
No. Our upfront pricing fixes the number in writing before we start, and we don’t add change orders for what we should have caught in the assessment. If we find hidden rot or structural issues, we stop, show you, and quote the fix before proceeding.
Every door we install is covered by our 730-Day Done Right Promise, one of the longest workmanship guarantees in residential construction. If the door sticks, leaks, or the hardware fails through a defect in our work, we come back and make it right.
Get Your Free Door Installation Estimate in Daly City
If you’re pricing door installation in Daly City, the fastest path is a free on-site estimate. We’ll measure the opening, check for rot and framing issues, walk you through door and hardware options, and hand you a written, line-item number before you commit to anything. No pressure, no surprise fees, and no voicemail, a live person answers every call. Reach us at (866) 320-2646. If your project also touches the wider scope, it’s worth seeing our Windows & Doors in Daly City page, or browsing the broader Windows & Doors service for the full picture on Daly City homes. Homeowners often pair this with Chain Link Fence in Daly City or Vinyl Fence in Daly City. We’re ready when you are.
Written by the team at Groundwork Construction Co.