Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Window Installation in San Anselmo, CA: What It Costs and How Long It Takes
Window installation in San Anselmo typically runs $4,500 – $15,000 for a whole-house replacement, and most jobs finish in one to three days once materials arrive. Standard vinyl and wood-clad units land at the low end. Impact-rated or custom-sized windows push toward $8,000 – $25,000. Lead times are the real variable here, not labor. Call (866) 320-2646 for a free on-site estimate with a written, line-item quote.
How our window installation process actually runs
Every job follows the same five stages. Here’s what happens and when, so you know what you’re deciding and what we’re handling.
Stage 1: On-site measure and window schedule (day 1, about 90 minutes)
We measure every opening, note the wall assembly (stucco, wood siding, or the tar-and-gravel detail common on older flats), and check for rot at the sill and header. You walk away with a written window schedule listing each unit’s size, glazing, and frame material. This is where you make your first real decision: standard sizes we can order fast, or custom sizes that add two to four weeks.
Stage 2: Order, permit, and lead time (one to five weeks)
Standard vinyl orders land in roughly two to three weeks. Wood-clad units from a brand like Andersen or Marvin typically run four to six weeks. If the scope touches the exterior envelope or changes an opening, we pull the permit through the Town of San Anselmo before anything ships. You’ll get a copy of the approved permit and the inspection schedule in writing.
Stage 3: Prep and demo (day 1 of install, half a day)
We lay drop cloths, remove interior trim, and cut out the old units. On early-1900s Craftsman homes in the flats, this is where we often find the surprise: rotted sill plates or knob-and-tube-era framing that needs sistering before the new window goes in. We document it with photos and give you a fixed price for the repair before we touch it. No change-order games.
Stage 4: Install, flash, and seal (days 2 – 3, the bulk of the work)
New units get set plumb and level, shimmed, and fastened per manufacturer spec. Flashing goes in at the sill and head, then we seal the perimeter and insulate the gap. On hillside homes toward Sleepy Hollow, wind-driven rain is the failure point, so we spend real time on the flashing detail. Most homes run two to three days of install.
Stage 5: Trim, inspection, and walkthrough (final day)
Interior trim goes back up, we caulk and paint the touch-up line, and the town inspector signs off if a permit was pulled. You get a walkthrough of every unit, the operation check, and the warranty paperwork. Any punch-list item gets fixed on the spot or scheduled within a week.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The window options you’ll choose between
- Vinyl frames: The budget workhorse at $450 – $900 per unit installed. Won’t rot, needs almost no upkeep, and suits the flats. The trade-off is a bulkier profile that looks wrong on a 1920s bungalow’s original trim detail.
- Wood-clad (Andersen, Marvin): Real wood inside, aluminum or fiberglass outside. Runs $900 – $1,800 per unit. This is the right call for Craftsman and bungalow homes where the interior trim is visible and worth matching. Longer lead times, higher cost.
- Fiberglass: $700 – $1,300 per unit. Holds paint better than vinyl and handles temperature swing without cracking. A solid middle path for hillside homes.
- Impact-rated glazing: $8,000 – $25,000 for a full house. Worth it on the wooded slopes where debris and wind load are the concern, and on any opening that faces the prevailing storm track off Mount Tamalpais.
- Glazing packages: Low-E, argon fill, and tempered glass each add cost per unit. Low-E pays back in a Marin winter; tempered is required near doors and low sills by code.
What window installation costs in San Anselmo, CA
Plan on $4,500 – $15,000 for a typical whole-house window installation in San Anselmo, or $8,000 – $25,000 when you’re specifying impact-rated or custom units throughout. Per-window installed pricing lands between $450 and $1,800 depending on frame and glazing. Five variables push you toward the high end:
- Unit count and size: Each opening adds $450 – $1,800. Picture windows and large sliders cost more than double-hungs.
- Existing condition: Rot at sills, headers, or framing adds repair cost. On older flats, budget a contingency.
- Custom vs. standard sizing: Custom adds 20 – 40% per unit plus weeks of lead time.
- Frame and glazing grade: Vinyl to wood-clad roughly doubles per-unit cost. Impact glazing more than doubles it again.
- Permit scope: Envelope changes and opening resizes require permits and inspections, which add fees and time.
Your written estimate covers units, labor, flashing, insulation, trim reinstall, caulk, and cleanup. It typically does not cover structural repair found after demo, exterior painting beyond touch-up, or blind and hardware reinstallation. Those get quoted separately and in writing before we proceed. This work is often scoped as part of a full Windows & Doors in San Anselmo project, and we coordinate it through our Windows & Doors service.
See the difference
Before
After
Before
After
Before
AfterWhat San Anselmo homes specifically do to this job
San Anselmo’s housing stock splits the job in two. The flats are early-1900s to 1950s Craftsman and bungalows, and those homes need window units matched to original trim profiles and their old sill details rebuilt correctly. The hillside homes climbing toward Sleepy Hollow and the Ross border are mid-century and later, and those face real wind load off Mount Tamalpais. Wet winters and atmospheric-river storms make flashing and wind-rated reinforcement the deciding factor on the slopes. Downtown along Sir Francis Drake Boulevard sits on a flood-prone flat, so any work near the creek can trigger Marin County flood-control review. Wildfire-risk interface rules along the wooded slopes also mean exterior materials should meet WUI ignition-resistant standards. If your project runs into fencing or site work, homeowners often pair this with a Wood Fence in San Anselmo or, for a lower-cost boundary line, a Chain Link Fence in San Anselmo. We cover the whole town and the 94960 and 94979 ZIPs, so find us on our San Anselmo service-area page.
Serving San Anselmo, CA – Our Local Coverage Area
We serve San Anselmo and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked: Window Installation in San Anselmo
Most window installation jobs in San Anselmo finish in one to three days of on-site work once materials arrive, with lead times of two to six weeks depending on frame and glazing. Standard vinyl units arrive fastest. Custom and wood-clad units take longer. Call (866) 320-2646 for a timeline specific to your home.
Yes, if the scope changes the exterior envelope or alters an opening size. Like-for-like replacement in the same opening often doesn’t require one, but the Town of San Anselmo and Marin County rules can tighten near the creek. We pull the permit and handle the inspection so you don’t have to guess. Call for a free scope review.
In most cases, yes. Window installation swaps units within existing openings, so plumbing and structure stay put. If demo reveals rotted framing, we repair it in place with a written price before proceeding. Structural changes only come up when you’re resizing openings.
Window installation in San Anselmo runs $4,500 – $15,000 for a typical whole-house job, and $8,000 – $25,000 for impact-rated or custom units. Per-window installed pricing is $450 – $1,800. Call (866) 320-2646 for an exact quote; estimates are free.
Every window installation we complete is covered by our 730-Day Done Right Promise, plus the manufacturer’s product warranty on the units themselves. If something isn’t right, we make it right. Call for the written warranty terms before you sign anything.
Get a free window installation estimate in San Anselmo
Call (866) 320-2646 to schedule a free on-site estimate for window installation in San Anselmo. We’ll measure every opening, walk you through frame and glazing options, and hand you a written, line-item quote with upfront pricing and no surprises. A live person answers around the clock. If the job runs past $10,000, you also get $1,000 off, and 0% financing for 18 months is available.
Written by the team at Groundwork Construction Co.