Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Vanities, Tile & Fixtures in Tiburon: What the Job Really Involves
Replacing a vanity, tiling a floor or shower surround, and swapping fixtures in Tiburon usually runs $9,000 – $28,000 depending on tile selection, vanity size, and whether plumbing or electrical has to move. Most jobs take two to four weeks of working days from demo to final caulk. If you’re pricing the work, call (866) 320-2646 for a free on-site estimate. We’ll walk the room, measure, and give you a written line-item quote before anything gets ordered.
How Our Vanities, Tile & Fixtures Work Moves, Stage by Stage
This isn’t a one-day swap. Vanities, tile, and fixtures come in a sequence, and each stage depends on the one before it. Here’s the actual order.
1. Measure, order, and stage (day 1)
We template the vanity footprint, check floor level, and confirm tile quantities against the layout, including a 10 – 15% waste allowance for cuts. You lock in the vanity, tile, and fixture selections now, because lead times on cabinetry and specialty tile can run two to three weeks. Nothing gets demoed until materials are on site.
2. Demo and prep (days 2 – 3)
Out comes the old vanity, toilet, tile, and any failing backer board. We pull the room down to framing and subfloor, then inspect for water damage behind the tile and around the drain, which is common in older Tiburon homes. Subfloor repair and backer board go in next; this is where a “simple tile job” can reveal rot that adds a day.
3. Rough-in and waterproofing (days 3 – 5)
If the vanity is relocating or the shower valve is being replaced, plumbing and electrical rough-in happen here, followed by inspection where required. Then we waterproof the wet areas. This step gets skipped by cheap crews and it’s the one that decides whether your tile lasts ten years or leaks in two.
4. Tile and vanity install (days 6 – 12)
Floor tile first, then wall tile, then grout and cure time. The vanity cabinet sets after tile, the countertop goes on, and the sink and faucet connect. You’re choosing grout color and trim profiles around this point. Expect two to four days just for setting and grouting a full bathroom.
5. Fixtures, trim, and final walkthrough (days 12 – 16)
Toilet, mirror, lighting, towel bars, and shower glass go in last. We caulk, clean, and walk the room with you. Anything that isn’t right gets fixed before we leave, and the work carries our 730-Day Done Right Promise: if it’s not done right, we make it right.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between for Your Vanity, Tile & Fixtures
Most of the decisions on this job come down to a handful of real trade-offs. Here’s what actually matters.
- Vanity type: A freestanding cabinet is the fastest and least expensive option, priced $800 – $3,000 installed. A wall-hung vanity frees floor space in a tight Tiburon bathroom but needs blocking in the wall. Built-in or custom cabinetry gives you the best fit in an oddly shaped room.
- Vanity top: Quartz and engineered stone resist moisture and stains and need no sealing. Natural stone looks richer but needs regular sealing. A cultured marble top is the budget pick.
- Tile material: Porcelain is dense, holds up to moisture, and comes in large formats that mean fewer grout lines. Ceramic is lighter and cheaper but softer. Natural stone (travertine, marble) is beautiful and needs sealing.
- Tile format and layout: Large-format tile reads clean and modern but demands a flat floor. Small hex or penny tile suits older bathrooms but means more grout to maintain. A herringbone or offset layout adds labor, not material.
- Fixtures and finishes: Brands like Grohe and Sterling cover the range from reliable everyday to premium. Brushed nickel and matte black hide water spots better than polished chrome. Salt air near the bay pushes us toward finishes that resist corrosion.
- Shower glass and trim: Frameless glass is cleaner-looking but costs more; framed glass is more forgiving on an out-of-square opening. Match faucet and shower trim to the vanity hardware for a coherent room.
What Vanities, Tile & Fixtures Cost in Tiburon, CA
Plan on $9,000 – $28,000 for a full vanities, tile, and fixtures job in Tiburon. The number swings on these variables:
- Room size: A small powder room sits near the low end. A full bathroom with a shower surround lands higher.
- Existing condition: Rotted subfloor, failing backer board, or old galvanized plumbing found during demo can add thousands.
- Relocating plumbing or electrical: Moving the vanity drain or adding a new light is a rough-in job and pushes toward the high end.
- Material grade: Porcelain and quartz sit mid-range; imported natural stone and custom cabinetry push the number up.
- Permit scope: Cosmetic tile and fixture swaps often don’t require a permit. Moving plumbing or structure typically does, and inspection adds time and cost.
A written estimate covers demo, prep, waterproofing, tile, vanity, fixtures, and labor. It usually excludes hidden damage found mid-job (quoted separately with your approval) and any structural work. Upfront pricing means the number you see is the number you pay. Call (866) 320-2646 for an exact quote; estimates are free.
See the difference
Before
After
Before
After
Before
AfterWhat Tiburon Homes Specifically Do to This Job
This is a steep-hillside peninsula, and that shapes the work before finish ever enters the picture. On the narrow winding streets above downtown and around Belvedere, getting tile, a vanity, and a tub up to the room can be its own project. Sometimes a delivery truck can’t reach the site and materials get walked or craned in. That access reality doesn’t exist in flatter Marin towns like Corte Madera, and it affects schedule and cost on nearly every Tiburon job we price.
The housing stock matters too. Homes range from early-1900s shingle and stucco cottages near downtown to mid-century hillside homes with cantilevered decks and large waterfront estates on Belvedere. Much of it is older and built into slopes, so subfloor condition and out-of-square walls are common, and tile layout has to work around them. The fog belt and winter rain mean constant moisture cycling on hillside exposures, which drives rot behind tile and around drains. Salt air off Richardson Bay corrodes fasteners and metal trim, so fixture finishes and waterproofing details matter more here than inland. If the wider project is part of a larger scope, see our Bathroom Remodeling in Tiburon page for the full-room version, and check Tiburon for the neighborhoods we cover. Homeowners often pair this interior work with Tile Roofing in Tiburon while access and staging are already set up.
Serving Tiburon, CA – Our Local Coverage Area
We serve Tiburon and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Vanities, Tile & Fixtures in Tiburon
Most run two to four weeks of working days, with tile and stone lead times adding on top. A powder-room refresh with a pre-fab vanity can finish faster; a full room with relocation and inspections takes longer. Call (866) 320-2646 and we’ll give you a schedule for your specific room.
Cosmetic work like tile replacement and swapping a vanity in the same spot usually doesn’t need a permit. Moving plumbing, electrical, or walls typically does. We confirm what your project requires during the estimate and pull permits where needed. Call (866) 320-2646 to talk through your scope.
Yes. Keeping the vanity, toilet, and shower in place lets you upgrade tile, fixtures, and the vanity top without a rough-in phase, which keeps cost near the low end of the range. Call (866) 320-2646 to find out what your current layout allows.
Expect $9,000 – $28,000 for a full job, with detail like stone selection and relocation pushing toward the high end. Tile-only or vanity-only scopes come in lower. Call (866) 320-2646 for an exact quote; estimates are free.
Every job is covered by our 730-Day Done Right Promise. If something isn’t done right, we make it right. That covers our workmanship; product warranties come from the manufacturer. Call (866) 320-2646 to review the details before you book.
Get a Free Vanities, Tile & Fixtures Estimate in Tiburon
Call (866) 320-2646 and a live person answers, any hour. We’ll schedule a free on-site estimate, measure the room, and hand you a written line-item quote with no surprises. Our technicians have up to 12 years of experience, and projects over $10,000 qualify for $1,000 off, with 0% financing for 18 months available. Start with the number, then decide.
Written by the team at Groundwork Construction Co.