Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Tub-to-Shower Conversion in Pacifica, CA: What It Costs and How Long It Takes
A tub-to-shower conversion in Pacifica typically runs $3,500 to $10,000 and takes 5 to 9 working days once permits are in hand: demo, rough-in adjustments, waterproofing, tile or panel finish, glass, and trim. Most of that window is cure time, not labor. If you’re deciding whether to keep a tub nobody uses or trade it for a walk-in shower, call (866) 320-2646 and we’ll walk your actual bathroom before anyone quotes a number.
How a Tub-to-Shower Conversion Actually Runs, Stage by Stage
Every Pacifica conversion we build follows the same sequence. The stages don’t compress much, because tile and waterproofing need real time to set. Here’s what you’ll see and what you’ll be deciding along the way.
Stage 1: Measure, scope, and written estimate (1 visit, then 2 – 3 days for the quote)
We measure the alcove, check the drain location, and open the wall behind the valve enough to see what’s actually there: galvanized supply lines, cast iron drain, old lead pan, or a previous homeowner’s patch job. That’s where the surprises hide in 1960s Pacifica ranches. You’ll get a written line-item quote before demo ever starts, and the number in that quote is the number you pay.
Stage 2: Permit and demo (1 – 2 days)
We pull the permit, then tear out the tub, surround, and old backer down to studs. This is the stage where we often find wet framing, especially on bathrooms along the west-facing exterior walls where fog-driven moisture has been working on the wood for years. If framing needs sistering, we stop and show you before proceeding. That’s a change to discuss, not a surprise on the final invoice.
Stage 3: Rough-in and inspection (2 – 3 days plus inspection scheduling)
Drain relocation, valve replacement, and blocking for grab bars or a bench happen here. Moving the drain from a tub position to a centered shower position is routine; moving the supply lines to the opposite wall costs more and takes longer. Our plumber is licensed, the work gets inspected, and we don’t close walls until that inspection passes.
Stage 4: Waterproofing and tile (2 – 4 days)
Cement board or a bonded waterproof membrane goes up, seams get taped and sealed, and the pan gets built or a prefab pan gets set. This is the stage where a bad contractor cuts corners and you find out two winters later. We don’t. Tile setting and grouting follow, with cure time between coats. You’ll choose tile here if you haven’t already.
Stage 5: Glass, fixtures, and final walkthrough (1 – 2 days)
Glass panels or a framed door get installed, the showerhead and valve trim go on, and we caulk, clean, and walk the job with you. Anything that isn’t right at that walkthrough gets fixed before final payment. Our 730-Day Done Right Promise backs the workmanship for two full years after that, in writing.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Choices That Actually Shape Your Tub-to-Shower Conversion
Every conversion involves the same handful of decisions, and each one moves both the budget and how the shower feels ten years out. Here’s what you’re really picking between.
- Tiled shower vs. prefab acrylic surround. Tile costs more up front, often $1,500 to $3,000 more in materials and labor, but lasts decades and can be repaired. Prefab panels from a brand like Sterling install in a day and are easy to clean, but they show scratches and can’t be patched convincingly. Tile suits a forever home; prefab suits a rental or a quick flip.
- Framed vs. frameless glass. Frameless glass runs $1,200 to $2,500 more but opens the room visually, which matters in a Pacifica ranch bath that was built tight. Framed glass is cheaper and sturdier but adds visual bulk.
- Drain position. Leaving the drain where the tub had it saves $400 to $900 in plumbing and concrete work. Centering it under a shower valve feels better but adds a day and some cost.
- Valve and trim grade. A basic pressure-balance valve works. A thermostatic valve from Grohe or a similar line gives you temperature control on cold coastal mornings and adds $300 to $800.
- Niche, bench, and grab bars. A recessed niche costs $150 to $400 installed. A bench adds $500 to $1,200 depending on whether it’s built or prefab. Grab bar blocking costs almost nothing if we plan it before the walls close, and a lot if we don’t.
If you’re also replacing the vanity or re-tiling the floor while the room is open, that’s part of a full Bathroom Remodeling in Pacifica and worth pricing together rather than as two separate jobs.
What Tub-to-Shower Conversion Costs in Pacifica, CA
Plan on $3,500 to $10,000 for the conversion itself. Most Pacifica jobs land between $5,000 and $8,000. Here’s what pushes one end of that range to the other:
- Size and layout. A standard 60-inch alcove is the cheap case. A wider or deeper shower requiring framing changes adds $1,000 to $2,500.
- Existing condition. Wet framing, a failed pan, or corroded galvanized supply lines behind the wall push the job up by $800 to $2,500 once we open things up.
- Plumbing and electrical moves. Relocating the drain or adding a light and fan circuit adds $500 to $1,800.
- Material grade. Tile selection alone can swing the job by $2,000. Porcelain is the workhorse; natural stone costs more and needs more sealing in a damp coastal bathroom.
- Permit scope. A straight fixture swap runs less than a job that touches framing or moves plumbing. In Pacifica’s coastal zone, any project that alters the structure can draw extra review, so the permit scope matters here more than inland.
A written estimate should include demo, permit, rough-in, waterproofing, tile or panels, glass, fixtures, cleanup, and disposal. It should not include structural repair found after demo, upgraded fixtures you select above the allowance, or any work that requires coastal review. We spell out allowances in writing so nothing gets padded later.
See the difference
Before
After
Before
After
Before
AfterWhat Pacifica Homes Specifically Do to This Job
Most bathroom work we do in Pacifica happens in 1950s to 1970s stucco-and-wood ranches and split-levels, and in the older beach cottages around Rockaway and Linda Mar. Those homes were built with tub alcoves framed against exterior walls, and in a fog-belt town with salt-laden onshore winds, that west-facing wall takes a beating. We routinely find soft framing and rusted fasteners behind tub surrounds, which is one reason we don’t quote a conversion sight-unseen. On the hillside and bluff lots along the San Mateo coast, construction carries coastal development permit and geotechnical realities that inland Peninsula cities don’t face, and while a bathroom conversion rarely triggers those conditions, it can when the work touches structure. Salt air also eats cheap fixtures fast. That’s why we lean on corrosion-resistant valve bodies and finishes rather than builder-grade chrome that pits in two years. And on the winter storm schedule, a shower left open with no waterproofing during a wet week is a leak waiting for the next storm front coming off the Pacific.
Serving Pacifica, CA – Our Local Coverage Area
We serve Pacifica and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Tub-to-Shower Conversion in Pacifica
Most conversions take 5 to 9 working days from demo to final walkthrough, with cure time accounting for much of it. Permit approval can add one to three weeks on the front end depending on scope. Call (866) 320-2646 for a realistic schedule based on your bathroom.
Yes. Any conversion that moves plumbing, replaces the drain, or alters framing requires a permit and inspection in Pacifica. We pull it, we schedule the inspection, and we don’t close walls until it passes.
Usually yes, and it’s the cheaper path. Keeping the drain in the tub position and using the existing valve location saves $400 to $1,800 and about a day of work. We’ll tell you at the estimate whether moving them is worth it.
Most jobs run $3,500 to $10,000, with the typical Pacifica project landing between $5,000 and $8,000. Material grade and what we find behind the wall are the two biggest variables. Call (866) 320-2646 for an exact figure; estimates are free.
Our 730-Day Done Right Promise covers workmanship for two years from completion. If something fails because of how we built it, we make it right. Materials carry their own manufacturer warranties through brands like Sterling and Grohe.
Homeowners planning exterior work alongside a bathroom project often pair this with Metal Roofing in Pacifica or Tile Roofing in Pacifica, since both trades compete for the same weather window. If you want the broader scope of our Bathroom Remodeling work, or you’re checking whether we cover your block in Pacifica, we can confirm on the first call.
Get a Free Tub-to-Shower Conversion Estimate in Pacifica
Call (866) 320-2646 and a live person answers, day or night. We’ll ask about your bathroom, your timeline, and whether the tub stays or goes, then schedule a free on-site estimate. You’ll get a written line-item quote with allowances spelled out and a start date. No pressure, no vague bids. Upfront pricing means the number in the quote is the number you pay, and the 730-Day Done Right Promise backs the work long after we’ve packed up.
Written by the team at Groundwork Construction Co.