Fence
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & paversFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Wood Fence Installation in Half Moon Bay, CA
A wood fence in Half Moon Bay, CA costs $3,500 – $9,000 for most residential properties, with the typical coastal lot landing between $4,800 and $7,200 for cedar or redwood with pressure-treated posts. Plan on a 2 – 4 day build once materials are staged, longer if the fence line needs rot repair at the posts. Call us at (866) 320-2646 to set up a free on-site estimate. Fence Installation
How we build a Wood Fence here, stage by stage
Wood fence work on the coast is a different sequence than a fence build in Sacramento, because the thing that kills a fence here is water at the base, not sun at the top. The order below is the one we follow.
Stage 1: Site walk and fence line survey (day 1, 60 – 90 minutes)
We walk the property line with you, mark the corners, and check the existing grade. On a sloped lot a straight-run fence needs stepping between posts, which changes post count and rail layout. You decide the height (typically 5 – 6 feet for privacy within the height limit), the exact line, and whether a gate goes at the driveway or a walkway.
Stage 2: Tear-out and soil assessment (day 1 – 2, 3 – 5 hours)
If there’s an old fence, we pull it and the posts. This is where coastal properties surprise you. Posts set in soil that stays wet from fog drip and irrigation often come out half rotted below grade, and the hole is soft. We read the soil, then decide set depth and whether the base needs additional drainage or concrete collars to keep the post from sitting in a bowl of water.
Stage 3: Post setting and curing (day 2 – 3, one full day plus curing)
Posts go in pressure-treated lumber, set in concrete below the frost-fog wet line, with the concrete crowned to shed water away from the wood rather than cupping it. We use hot-dip galvanized or stainless fasteners throughout. On exposed coastal lots we look at stainless. Posts set in the ground with water pooling at the base is a fence-killer far more than wind.
Stage 4: Rails, boards, and finish (day 3 – 4, 6 – 8 hours)
Rails get fastened to posts, boards are run, and gaps are set so the wood can move. You choose board spacing (tight for privacy, spaced for wind pass-through), styles (dog-ear vs flat-top), and finish. A penetrating oil-based stain or a clear sealer gets applied after drying. On the damp coast, a moisture-barrier mindset applies to fence boards the same way it does to siding.
Stage 5: Final walk and documentation (same day, 30 minutes)
We walk the run with you, check plumb, gate swing, and post integrity, and hand over the care notes. A written warranty covers the workmanship, and the 730-Day Done Right Promise backs it. If a post pulls, we come back.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The options you’ll choose between on a Wood Fence
The specs matter more on the coast, because a cheap board that survives 15 years inland may not survive 8 years with salt spray and fog.
- Cedar boards – the coastal standard. Cedar resists rot better than most softwoods, holds stain well, and looks right against Half Moon Bay’s older wood-sided homes. Cost runs higher than pine.
- Redwood boards – the premium wood option. Takes stain beautifully, naturally rot-resistant, and pairs well with existing wood deck and balcony structures. Highest material cost.
- Pressure-treated pine – the budget option. Fine for fence framing and posts, but boards on a fog-soaked south-facing run may show fast weathering. Recommend a heavier stain schedule.
- Post specs – pressure-treated 4×4 is the baseline; 4×6 or larger on long runs and wind-exposed ridgelines reduce wobble.
- Fasteners and hardware – hot-dip galvanized or stainless. On salt-air sites, stainless for hinges and gate hardware pays back in 4 – 6 years versus a rusted replacement cycle.
- Board style – dog-ear privacy (most common), flat-top, or spaced wind-pass boards where gusts channel through the property line.
- Gate and style – a single walk gate or a double-drive gate. Gates on coastal properties often need stainless hinges and a heavier post to hold up.
What a Wood Fence costs in Half Moon Bay, CA
The market range for wood fence in Half Moon Bay is $3,500 – $9,000, with the number driven by footage, board material, post condition, and grade. A typical 100-foot privacy run in cedar lands in the $5,500 – $7,500 band. Shorter runs, simpler styles, and pressure-treated boards push toward $3,500. Long runs, sloped or rocky lots, and redwood or decorative panels push toward $9,000.
What moves the number
- Footage – the single biggest driver. Every additional 100 feet adds real material and labor.
- Board material grade – pressure-treated pine at the low end, cedar mid, redwood at the top. A 20 – 30% material swing between pine and redwood is normal.
- Existing fence and post condition – old fence tear-out and rotted post removal adds 4 – 8 hours of labor, plus concrete haul-away.
- Grade and access – sloped lots, tight side yards, or a run that requires hand-carrying materials uphill add labor.
- Gate and hardware – gates with stainless hardware and heavier posts add a few hundred to the estimate.
- Permit scope – most residential fences stay under the height threshold and don’t trigger a permit, but taller fences, fences near coastal review areas, or corner-lot visibility rules may require review; we tell you upfront if yours falls into that category.
What a written estimate includes
Demolition and haul-away of the old fence, all posts, rails, boards, concrete, fasteners, and finish applied, plus site cleanup. Excluded in most cases: major rot repair at the house or detached structures the fence ties into, and permit fees if applicable.
See the difference
Before
After
Before
After
Before
AfterWhat Half Moon Bay homes specifically do to this job
Half Moon Bay sits in a coastal fog belt on the San Mateo County coast, and the marine air, salt spray, and persistent damp change what a wood fence has to survive. Fasteners rust faster, posts sit wetter, and the wood siding on the older homes here tells the story. In 94019, the housing stock runs from 1960s-70s ranch homes in neighborhoods like Ocean Colony and Alsace Lorraine to newer custom builds, many with wood siding, wood-framed decks, and cantilevered balconies facing the marine air. Rot repair at the fence line is routine, not occasional.
Coastal zoning overlay and Coastal Commission review add time to projects here, especially along the ocean-facing edge and in flood zones. That review reality means we build in extra lead time for materials staging and inspection when a fence line crosses a review boundary. The Half Moon Bay wind-driven moisture also means we detail for drainage and corrosion-resistant hardware, not just appearance. The fog belt drives the failure pattern: posts and lower rails rot from the base up long before the top boards give. Homeowners here often pair a new fence with our Fence Installation in Half Moon Bay service, and where a driveway is part of the same project, many pair it with Paver Driveways in Half Moon Bay or Concrete Driveways & Concrete Work in Half Moon Bay.
Serving Half Moon Bay, CA – Our Local Coverage Area
We serve Half Moon Bay and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked – Wood Fence in Half Moon Bay
A typical residential wood fence runs 2 – 4 days on site after materials are staged, with most of that being footings, posts, and boards. Permit review, if your line crosses a coastal review boundary, adds lead time before the build starts. Call (866) 320-2646 for a timeline on your property.
Most residential wood fences under the standard height limit don’t trigger a permit, but coastal zoning, flood zones, and corner-lot visibility rules can change that. We tell you the permit status before work starts. Call (866) 320-2646 to review your line.
Not for pre-agreed scope. The written estimate is the number you pay, with no surprises. The one thing we can’t see until the old fence comes out is rot at the post base or at a structure where the fence ties in, and if that shows up we price it before we touch it. Call (866) 320-2646 for a firm number.
Cedar or redwood with pressure-treated posts and stainless or hot-dip galvanized hardware is the coastal-resilient combination. Pressure-treated pine is the budget route with a heavier stain schedule. Call (866) 320-2646 to pick the spec that matches your lot.
The range is $3,500 – $9,000, with a typical 100-foot cedar privacy run at $5,500 – $7,500. Call (866) 320-2646 for an exact quote – estimates are free.
Get a free estimate on your Wood Fence
If you’re ready to price a Wood Fence in Half Moon Bay, call (866) 320-2646 for a free on-site estimate. We walk the line, measure the footage, check post condition, and hand you a written line-item quote. Live person answers 24/7. Our technicians have up to 12 years of experience, and every job is backed by the 730-Day Done Right Promise. Where your project reaches beyond the fence line, our Half Moon Bay team covers the full scope.
Written by the team at Groundwork Construction Co.