Fence
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & paversFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Chain Link Fence in Tiburon, CA: What It Costs and How Fast It Goes Up
A chain link fence in Tiburon usually runs $3,500 – $9,000 installed, depending on height, gauge and how hard the site is to reach. Most residential runs are measured and set in a single day, with posts set in concrete and mesh stretched on a second visit roughly 24 to 48 hours later. On the hillside lots above downtown and around Belvedere, access planning often adds more to the schedule than the fence itself. Call (866) 320-2646 for a free on-site estimate.
How We Build a Chain Link Fence Here, Stage by Stage
Chain link is a simple product, but the sequence matters, and on Tiburon’s slopes the staging is half the job. Here’s what actually happens, in order.
Stage 1: Site visit and layout (day 1, about 60 – 90 minutes). We walk the property line and confirm it against the plat, mark post spacing at 8- or 10-foot intervals, and descend any grade changes. This is where you decide fence height (4, 5 or 6 feet), gate placement and whether the run follows the slope or steps down in panels. On hillside lots, you also tell us where we can park a truck and how far material has to be carried.
Stage 2: Utility locate and access plan (1 – 3 business days before dig day). We call for underground utility marking before any post hole is augured. In Tiburon’s older neighborhoods, irrigation lines and old landscape wiring turn up more often than you’d expect. Simultaneously we plan the material drop: on tight streets off Main Street, we may stage chain link rolls and concrete bags at the street and walk them up, since a delivery truck isn’t getting down a hairpin driveway.
Stage 3: Demolition and post setting (dig day, one long day). If there’s an old fence, it comes out first. Then holes go down 24 – 36 inches depending on soil and frost depth, posts are plumbed, and concrete is poured and left to cure. You’ll sign off on the post line and gate swing before we leave.
Stage 4: Rails, mesh and gates (cure day, typically 24 – 48 hours later). Top rail, tension bands, mesh and gate hardware go on. This is the day the fence starts looking like a fence. Tensioning on sloped runs takes longer than flat ones.
Stage 5: Walkthrough and cleanup (same day as stage 4). We test every gate, check mesh tension, sweep for cut wire and concrete splatter, and hand you the workmanship details in writing. That’s the whole job on a standard residential run.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Actually Choose Between
Chain link isn’t one product. These are the decisions that change both the look and the price:
- Gauge and coating: 11.5-gauge galvanized mesh is the standard residential choice and holds up well. Heavier 9-gauge mesh costs more but resists impact and climbing pressure, which matters on a security-focused property line. Vinyl-coated mesh (black or green) adds cost but reads less like a ballfield and more like a deliberate property boundary.
- Height: 4-foot fence suits a low garden boundary; 5-foot is the common middle; 6-foot is the practical security height. Every extra foot changes post size, concrete volume and price.
- Post and rail: Standard 1⅝-inch line posts with a top rail are the baseline. Heavier 2⅜-inch posts and a bottom rail cost more but hold tension better on long runs and steep grades.
- Gate type: A walk gate is standard; a drive gate needs heavier posts and a proper hinge set. If you plan to automate the gate later, say so now so the posts are sized for it.
- Finials and privacy add-ons: Slat inserts or privacy tape can be added later if you want screening without going to a solid fence.
What a Chain Link Fence Costs in Tiburon, CA
The installed range for a residential chain link fence in Tiburon is $3,500 – $9,000. A short, flat, 4-foot run on an accessible lot sits near the bottom. A long perimeter with multiple gates, vinyl coating, and a hillside carry-in lands near the top. Here’s what moves the number:
- Linear feet and height: The biggest driver. More feet means more posts, concrete and mesh.
- Existing fence removal: Tearing out and disposing of an old run adds labor and hauling.
- Site access: If material must be walked or craned in because a truck can’t reach, that’s billed as staging labor, and it’s real money on hillside lots.
- Gauge and coating upgrades: Heavier mesh and vinyl coating add cost per foot.
- Gates: Each gate, especially a drive gate, adds posts, hardware and installation time.
A written estimate from us is line-itemed: footage, height, gauge, coating, gates, removal and staging. Permits and any utility locate fees are listed separately if they apply. What’s not included is anything you haven’t asked for, and we don’t add change orders mid-job.
See the difference
Before
After
Before
After
Before
AfterWhat Tiburon Homes Specifically Do to This Job
Tiburon is a steep-hillside peninsula town where narrow winding access roads and tight lots drive cost and schedule more than the fence itself. On the streets above Main Street and around Belvedere, a dumpster or concrete truck often can’t reach the site, so materials get walked or craned in. That’s the reality that separates a Tiburon job from a flat-lot job in Corte Madera or Mill Valley. On the bayfront and toward the peninsula tip, salt air off Richardson Bay corrodes fasteners and galvanized hardware faster than inland, which is why we spec coated or stainless components on exposed runs. The housing stock ranges from early-1900s shingle cottages near downtown to mid-century hillside homes with cantilevered decks, and often the fence line follows a retaining wall or property line that isn’t straight. We see that breakage as much as the fence itself.
Serving Tiburon, CA – Our Local Coverage Area
We serve Tiburon and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Chain Link Fence in Tiburon
A standard residential chain link fence in Tiburon is typically installed over two visits: one day for demolition and post setting, and a second for rails, mesh and gates. That second visit usually lands 24 to 48 hours after concrete cures. Larger runs, steep grades or difficult access can stretch the schedule. Call (866) 320-2646 for a timeline specific to your lot.
Most residential fences in Tiburon fall under height and setback rules, and a permit is often required above a certain height or on a corner lot. Waterfront properties can face additional design review. We confirm what’s required for your specific property before any digging. Call (866) 320-2646 and we’ll walk you through the local requirements during your free estimate.
Yes, in most cases we hand-dig around existing planting and remove only the sod directly under the post line. On hillside lots where we have to carry materials up, we stage at the street and protect the route. If a path or retaining wall is in the way, we’ll talk through options before we start. Call (866) 320-2646 to schedule an on-site look.
The installed range for a residential chain link fence in Tiburon is $3,500 – $9,000, depending on footage, height, gauge, gates and access difficulty. Steep or tight-access lots push toward the higher end. Call (866) 320-2646 for an exact written quote, and estimates are free.
Every chain link fence we install is covered by our 730-Day Done Right Promise: if it isn’t done right, we make it right. That covers workmanship on posts, tensioning and gate hardware for two full years. Call (866) 320-2646 with any warranty question.
Get a Free Chain Link Fence Estimate in Tiburon
We’ll come to your property, walk the line with you, and hand you a written, line-itemed estimate for your chain link fence in Tiburon. No pressure, no vague ranges. Call (866) 320-2646 and a live person picks up, day or night. You’ll leave the call knowing your footage, your options and your number.
Written by the team at Groundwork Construction Co. of San Francisco.