Windows & doors
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Impact Windows & Doors in Tiburon: What the Job Really Involves
Impact Windows & Doors in Tiburon usually runs $8,000 – $25,000 for a typical whole-house package, and most homes take two to four days on site once the units arrive. The work means pulling the old glazing and frames, verifying the rough openings, flashing and sealing against wind-driven rain, then setting rated units that hold up to salt air and hillside gusts. Call (866) 320-2646 for a free on-site estimate.
How We Run an Impact Window & Door Project Here
Every house on a slope is its own logistics problem, so the sequence below is what actually happens, not a brochure version of it.
Stage 1: Walkthrough and field measure (day 1, about 90 minutes)
We measure every opening from the inside and confirm the wall assembly behind the trim, because older Tiburon homes hide surprises under siding. You decide then which openings get impact-rated units and which stay standard, since not every bedroom needs the same rating.
Stage 2: Order, lead time, and permit (1 to 5 weeks)
Impact units are built to size, so lead times typically run three to five weeks. We pull the permit and confirm any coastal or design-review requirements before the order goes in, so nothing gets built twice. You approve the final finish and hardware schedule during this window.
Stage 3: Site protection and staging (day 1 of install, 2 to 3 hours)
This is the stage that separates a hillside job from a flat-lot job. On narrow access above Main Street, we plan where the units stage and how they get to the opening before anything is unloaded. Floors and landscaping get covered, and the work zone is sealed off from the rest of the house.
Stage 4: Removal and installation (days 2 to 3, longer on bigger packages)
We cut out the old units, check the framing and sheathing, replace any rot, then set the new units in a bed of sealant with proper flashing at head and sill. Doors get the same treatment, plus shimming and hardware alignment. Most homes see four to eight openings a day with a two-person crew.
Stage 5: Sealing, trim, and inspection (final day, 4 to 6 hours)
Interior trim goes back, exterior joints get sealed, and we test every sash, lock, and door swing. The inspection follows, and we walk the job with you before we call it done. Anything that isn’t right gets corrected on the spot, backed by our 730-Day Done Right Promise.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Choices You’ll Actually Make
Most of the decisions happen in the first week, and they drive both the budget and how the house performs for the next twenty years.
- Glass package: laminated impact glass is the standard choice for wind-borne debris zones; some homeowners mix in a tempered or laminated hybrid on shaded exposures. The trade-off is cost versus peace of mind, and laminated glass adds to the unit price.
- Frame material: vinyl is the value play and holds up well with salt air if the hardware is stainless; aluminum stays crisp on contemporary hillside homes but needs a thermal break; wood-clad gives the warm look many older Tiburon cottages have, at a premium. We work with Andersen and Marvin where the spec calls for them.
- Style and configuration: casement and awning units seal tighter against wind-driven rain than sliders; fixed picture units let you go bigger for less money. You pick operation per opening.
- Doors: entry and patio doors need the same impact rating as the windows, and hardware finish matters near the water. Therma-Tru and ECO Window Systems cover most of what we install.
- Finish and hardware: factory finish versus paint, and hardware color codes so the exterior reads as one system.
What Impact Windows & Doors Costs in Tiburon, CA
Expect $8,000 – $25,000 for a whole-house impact package. A single opening typically runs $900 – $2,200 installed depending on size and frame material, and that’s the number that makes the range feel real once you count bedrooms, living areas, and doors.
What pushes a project toward the top of the range:
- Opening count and size: a hillside contemporary with floor-to-ceiling glass costs more than a cottage with standard double-hungs.
- Existing condition: rotted trim, failed flashing, or out-of-square rough openings mean carpentry before the unit goes in.
- Access and staging: hairpin driveways and tight lots can require crane picks or walking materials in, and that labor shows up in the price.
- Frame material and glass grade: wood-clad and laminated assemblies sit at the high end; vinyl with standard impact glass sits lower.
- Permit and design-review scope: coastal or design-review requirements add time and paperwork, not just fees.
A written estimate should list every opening, the unit spec, the labor, permit costs, and disposal. It should not bury trim repair or reveal replacement in a change order later. Upfront pricing means the number you see is the number you pay. What’s usually outside the estimate: structural repair if framing is compromised, and interior painting beyond touch-up.
See the difference
Before
After
Before
After
Before
AfterWhat Tiburon Homes Specifically Do to This Job
Tiburon is a steep-hillside peninsula town, and that shapes this job as much as the climate does. Access drives schedule and cost here more than on a flat lot in Corte Madera: on the winding streets above downtown and around Belvedere, we plan staging, crane picks, and material handling around limited parking before we ever price the units. Salt air off Richardson Bay eats at fasteners, flashing, and metal hardware, so we spec stainless and marine-grade where it counts. The housing stock runs from early-1900s shingle cottages near downtown to mid-century and contemporary hillside homes with cantilevered decks, plus large waterfront estates. On the older homes we regularly find original single-pane windows with failed glazing putty and soft sill wood, and that rot has to be repaired before a new unit goes in. The fog belt and winter rain cycling across south- and west-facing exposures is what causes the trim rot in the first place. Our team covers Tiburon and the surrounding Marin towns, and we walk each property to confirm what the hillside will actually allow. Impact windows and doors are often part of a full Windows & Doors in Tiburon scope, and homeowners often pair this with Aluminum Fence in Tiburon work on the same property. If a gate or handrail needs replacing near the water, Iron Fence in Tiburon is the other job we get asked about most. You can see the wider range of work at our Windows & Doors service hub.
Serving Tiburon, CA – Our Local Coverage Area
We serve Tiburon and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Impact Windows & Doors in Tiburon
A typical whole-house package takes two to four days on site after a three-to-five-week lead time for the units. Hillside access and rotted trim can add a day. Call (866) 320-2646 for a firm schedule after the walkthrough.
Yes, window and door replacements require a permit, and coastal or design-review requirements can add steps depending on location. We pull the permit and handle the inspection as part of the job. Call (866) 320-2646 to confirm what your address needs.
Yes, in most cases the existing rough opening is reused and no structure or plumbing moves. If framing is compromised or a door relocation is involved, that’s flagged before work starts. We give you a written line-item quote so there are no surprises.
Expect $8,000 – $25,000 for a whole-house package, with single openings around $900 – $2,200 installed depending on size and frame material. Access and existing condition move that number most. Free estimates are available and quotes are written line by line.
Our 730-Day Done Right Promise covers workmanship for two years, and the manufacturer covers the units. If something isn’t right, we make it right. Call (866) 320-2646 and we’ll walk you through the details on your specific spec.
Get a Free Impact Windows & Doors Estimate in Tiburon
We’ll walk your property, measure every opening, and give you a written line-item estimate covering unit specs, labor, and permit costs. A live person answers the phone, 24/7, at (866) 320-2646, so you’re never stuck waiting for a callback. From that first conversation, you’ll know what your Impact Windows & Doors project in Tiburon actually costs and what’s included before you commit to anything.
Written by the team at Groundwork Construction Co.