Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Driveway Repair & Replacement in San Bruno, CA: What It Takes and What It Costs
Driveway repair and replacement in San Bruno usually runs $5,000 to $14,000 for a full replacement, with smaller crack and panel repairs well below that. Most driveways here get torn out and repoured in three to five working days, depending on size, slope and how much of the old slab has to come out by hand. The number you’ll actually pay depends on square footage, the material you pick and what’s underneath the old surface. Call (866) 320-2646 and we’ll walk your driveway and give you a written, line-item number before anyone touches a shovel.
How a Driveway Repair & Replacement Job Actually Runs
Every driveway is a little different, but the sequence in San Bruno rarely changes. Here’s what the days look like so you know what to expect and when you’ll be asked to make a call.
Day 1 – Walkthrough, layout and protection
We mark the new driveway edges with paint or string, confirm slope and drainage direction, and note anything buried nearby (sprinkler lines, gas, sewer cleanouts). You approve the final layout before demo starts. We cover landscape beds and pull any gates that would block the machine. This is also where you lock in the material: concrete, pavers or asphalt.
Day 1 – 2 – Demolition and haul-off
The old slab comes up. A typical two-car driveway takes one long day with a skid-steer and a jackhammer for the edges; tight side yards and steep San Bruno lots slow it down and we’ll tell you upfront if that applies to you. Broken concrete goes into a dumpster on site, not a pile at the curb. Exposed subgrade gets inspected for soft spots.
Day 2 – 3 – Base prep and grading
This is the step most shortcuts skip. We re-grade the base to shed water toward the street or a drain, compact in lifts, and check the fall with a level so water doesn’t pool against the garage door. If the soil is clay-heavy or the old base was never compacted, we bring in crushed aggregate. You’ll see the base before it’s covered – if you want to look, ask and we’ll hold the pour.
Day 3 – 4 – Pour, set or lay
Concrete gets placed, screeded and finished in a single push; expansion joints go in where the slab meets the garage, sidewalk or a wing wall. Paver driveways get set on a compacted sand or aggregate base with edge restraints. Asphalt is laid hot and rolled. You decide finish details (broom, exposed aggregate, joint layout) before the pour starts, not after.
Day 4 – 5 – Cure, cleanup and cure-window instructions
Concrete needs to cure before you drive on it – typically a few days for foot traffic and longer for vehicles, and we leave you the exact schedule in writing. We pull forms, clean up, and walk the finished surface with you. Any issue inside the 730-Day Done Right Promise gets fixed by us, not argued about.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between
Material is the biggest single lever on price, and each one has an honest trade-off. Here’s how they compare for a San Bruno driveway:
- Concrete ($4,500 – $12,000 installed): The most common choice on the Peninsula. Durable, low maintenance, easy to repair panel-by-panel. The downside is cracking if the base isn’t right, and it can look plain unless you specify a broom finish or aggregate.
- Pavers ($7,000 – $18,000): The premium option. Individual units can be lifted and reset if one settles or a utility line needs digging, which concrete can’t do. Higher upfront cost, and the base prep has to be meticulous or the surface will shift.
- Asphalt ($3,500 – $9,000): The budget-friendly pick. Smooth, fast to install, quick to resurface. It needs sealing every few years and softens in extreme heat, but for a driveway that sees light traffic it holds up fine.
- Repair instead of replace: If the slab is sound and only a few panels or the apron are failing, patching and crack sealing can stretch the life of what’s there. We’ll tell you honestly when repair is throwing money at a slab that’s already gone.
For a broader material walkthrough, see our Driveway & Pavers service.
What Driveway Repair & Replacement Costs in San Bruno, CA
Expect $5,000 – $14,000 for a full driveway replacement in San Bruno, with the exact number driven by these factors:
- Square footage: A single-car apron is one number; a long two-car drive with a turnaround is another. Roughly 300 – 600 sq ft is typical for the neighborhood lots here.
- Existing condition: A slab that comes up clean costs less than one with tree roots, failed base or concrete that’s bonded to a stem wall.
- Access and slope: Tight side yards, steep grades and gates mean more hand work and more labor hours.
- Material grade: Standard gray concrete vs. exposed aggregate vs. pavers vs. asphalt shifts the total by thousands.
- Drainage and utility work: Adding a trench drain, relocating a downspout or protecting a gas line or sewer cleanout adds scope.
Your written estimate should itemize demo, haul-off, base prep, material, finishing and cleanup. What it typically doesn’t cover: unforeseen utility conflicts, soil that needs full replacement, or permits if your project triggers one. We flag those before work starts so the number you see is the number you pay.
See the difference
Before
After
Before
After
Before
AfterWhat San Bruno Homes Specifically Do to This Job
San Bruno’s construction landscape still carries the fingerprints of the 2010 PG&E gas pipeline explosion in the Crestmoor neighborhood. That event set off a mandatory seismic retrofit and rebuilding wave that reshaped how the city handles permits and inspections, and it means driveways here sit in front of an unusually mixed housing stock: rebuilt, seismic-compliant homes next to 1940s-50s originals that still need foundation bolting and shear walling. When we dig up a driveway in Crestmoor or the surrounding blocks, we’re careful about what’s under the slab. Contractors working in the 94066 zip have to know the PG&E gas line clearance procedures, because digging near the former blast zone can require a locate and clearance before a machine goes in. If your driveway replacement is part of a larger rebuild, homeowners often pair this with an ADU Site Prep & Utilities in San Bruno job or a Junior ADU & Interior Conversion in San Bruno project, and we’ll sequence the drive so the concrete isn’t poured before the trenching is done. The fog belt matters too – cool, damp summers and steady onshore winds off the Pacific mean moisture hangs around, so proper grading and drainage away from the garage is not optional here; a slab that ponds water against the door will rot the framing behind it.
Serving San Bruno, CA – Our Local Coverage Area
We serve San Bruno and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Driveway Repair & Replacement in San Bruno
Most full replacements finish in three to five working days from demo to final cleanup, with concrete needing additional cure time before you drive on it. Tight lots or heavy base repair can stretch that. Call (866) 320-2646 for a schedule estimate on your specific driveway.
Many like-for-like replacements don’t require a permit, but projects that change the curb cut, alter drainage or tie into a larger structural or ADU scope often do. We check the requirement against your specific project and pull what’s needed. Call (866) 320-2646 and we’ll tell you what yours falls under – the estimate is free.
Yes, if the base is stable and only isolated panels or the apron are failing. Crack sealing and panel replacement can buy years. If the slab is already shifting or the base has failed, patching won’t hold. We’ll tell you which side of that line you’re on.
Full replacement typically runs $5,000 – $14,000 depending on size, material and how much base prep is needed. Concrete sits at the lower-middle of that, pavers at the top. Call (866) 320-2646 for an exact line-item quote – estimates are free.
Every driveway we install is covered by the 730-Day Done Right Promise: if something isn’t right, we make it right. That covers our workmanship; material manufacturer warranties apply on top of that. Call (866) 320-2646 to schedule your free on-site estimate.
Get a Free Driveway Repair & Replacement Estimate in San Bruno
Call (866) 320-2646 and we’ll set up a free on-site estimate for your driveway repair or replacement in San Bruno. A live person answers around the clock, so you won’t hit voicemail. We’ll walk the driveway with you, measure, and hand you a written line-item quote with no surprises. If your project is part of a bigger scope, start with our Driveway & Pavers in San Bruno page or our San Bruno service area.
Written by the team at Groundwork Construction Co.