Fence
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & paversFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Aluminum Fence in San Rafael, CA: What It Costs and How Long It Takes
Aluminum fence installation in San Rafael, CA runs $4,000 to $10,000 for most residential lots, and a typical job is measured, permitted where required, and built over two to four weeks from signed estimate to final walkthrough. The material itself is lighter than wood or steel and won’t rot, warp, or feed termites, which matters on the older lots around here. Call (866) 320-2646 and we’ll set a free on-site estimate.
How We Build an Aluminum Fence, Start to Finish
Aluminum fencing looks simple from the street. Underneath, it’s posts set at real depth, rails that stay level on ground that usually isn’t, and gate hardware that still swings clean in year five. Here’s the sequence we run in San Rafael.
Stage 1: On-site measure and layout (day 1, about 90 minutes)
We walk the property line with you, verify setbacks, and mark every post location with paint. This is where you decide fence height and whether the run follows the grade or steps down in panels. On sloped lots in the hills above downtown, stepped panels almost always look better than a raked run, and we’ll show you both on paper before you commit.
Stage 2: Utility locate and permit filing (days 1 to 5)
We call in the utility locate before anyone digs, which is non-negotiable on established San Rafael properties where irrigation lines, old gas stubs, and low-voltage lighting are buried in places nobody remembers. If your fence crosses a property line, runs over a certain height, or sits in a front setback, we file the fence permit with the city and pull it under our name. You decide nothing at this stage except whether you want the gate on the driveway side or the walkway side.
Stage 3: Demolition and post setting (days 6 to 8)
Old fencing comes out and goes to haul-away. Posts get set in concrete at a depth suited to the soil and the wind load, and we brace and check plumb as we go. Aluminum posts are lighter than wood, so accurate spacing matters more than brute strength; a post set a few inches off will show up as a sagging gate within a season. Concrete cures before any panel goes on.
Stage 4: Panels, rails, and gates (days 9 to 12)
Rails and pickets go up section by section, with racked or stepped transitions wherever the grade changes. Gates get their hinges, latch, and closer set so they swing true and latch with one hand. This is the stage where you see the fence line for the first time, and where we correct anything that reads wrong before we call it done.
Stage 5: Walkthrough and touch-up (day 12 to 14)
We walk the whole run with you, check every post, gate, and fastener, touch up any scratches in the finish, and leave the site clean. If your project is part of a full Fence Installation in San Rafael scope that includes gates or a matching side yard, we sequence this run so the whole perimeter finishes together.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Choices You’ll Actually Make on an Aluminum Fence
Most of the decisions on an aluminum fence happen before we order material. Here’s what genuinely changes the job, and what each option costs you in dollars or in holding up over time.
- Residential vs. industrial grade: Residential panels are lighter and cheaper, and they’re fine for a backyard boundary. Industrial grade uses thicker pickets and heavier rails, and it’s what you want on a street-facing run where a dog leans on it daily or where the fence takes wind off the hills. It adds real cost but extends the life of the run.
- Powder-coat finish color: Black is the standard and hides dirt best. Bronze and architectural colors cost more and can carry a longer lead time. The finish is baked on, so it doesn’t peel like paint, but a cheap coat on a bargain panel will chalk within a few years.
- Picket spacing and height: A 4-foot fence with 4-inch spacing keeps a small dog in. A 5- or 6-foot run with tighter spacing is what you need for a pool enclosure or a privacy screen. Height and spacing both drive material cost.
- Racked vs. stepped panels: Racked panels follow the slope in a continuous line. Stepped panels drop level from post to post. On a steep hillside lot, racked looks cleaner; on a shallow grade, stepped is often the better value.
- Gate style and hardware: A standard walk gate is inexpensive. A double drive gate with self-closing hinges and a keyed latch is a bigger line item, and it’s the piece most likely to fail first, so we spec hardware that can be serviced.
If you’re also reworking the apron or approach where the fence meets the street, homeowners often pair this with Driveway Repair & Replacement in San Rafael so the gate and the pavement finish together.
What Aluminum Fence Costs in San Rafael, CA
Expect $4,000 to $10,000 for a residential aluminum fence in San Rafael, depending on linear footage, grade, gate count, and whether old fencing has to come out. A basic 100-foot backyard run on flat ground sits near the low end. A long street-facing run on a stepped hillside lot with two gates and industrial-grade panels sits near the top.
Four things push the number up or down:
- Linear footage and gate count: Material and labor both scale with length. Each gate is a separate line item.
- Grade and soil: Steep lots need more posts, more concrete, and more layout time. Hillside soil in the neighborhoods above Dominican sometimes needs deeper footings.
- Existing fence removal: Tear-out and haul-away is real labor. A clean removal is cheap; a rotted wood fence tangled in roots and vines is not.
- Permit scope: A simple side-yard run may need no permit at all. A front-yard fence or one over the height threshold adds filing time and a fee.
Your written estimate is line-item: footage, panel grade, finish, gates, hardware, removal, and permit fees, each with its own number. The number you see is the number you pay. What’s not included is anything we couldn’t see on the walk: hidden utility relocation, a retaining wall that has to move, or a property-line dispute that changes the run.
See the difference
Before
After
Before
After
Before
AfterWhat San Rafael Homes Specifically Do to This Job
San Rafael isn’t a new-subdivision town, and that shapes aluminum fence work here. The lots we measure most often sit in the older settled neighborhoods like the West End, Gerard, and the Dominican area, where craftsman and bungalow homes were built before the 1970s under some of California’s more layered permitting regimes. That means a fence crossing a property line often runs into a survey question rather than a clean mark, and a front-yard run can need city review plus, in areas with coastal or older overlays, added documentation. We build that filing time into the schedule up front so you’re not surprised by a two-week review.
The hillside neighborhoods above downtown and Dominican are their own story. Those homes sit on steep lots behind older retaining walls and cribbing, and we regularly find drainage and slope issues that a flat-lot job never touches. On a fence run, that shows up as footings that need engineering input and a post line that has to respect the retaining wall rather than fight it.
San Rafael’s warm central Marin climate is kinder to aluminum than wood; it won’t rot the way a wood fence does through wet winters. But winter rain concentrates runoff down those hills, and a fence set right where water sheets off a slope will undercut its own footings. We set posts and grade the ground around them with that in mind. In areas with wildfire exposure, an aluminum fence with non-combustible panels is also a defensible-space choice that some insurance carriers look on favorably. If the fence is one piece of a bigger yard rebuild, homeowners often pair this with Patios, Walkways & Pool Decks in San Rafael, and you can see the full breadth of our Fence Installation work on the main service page. We cover all of San Rafael, including the 94901, 94903, and 94912 ZIP codes.
Serving San Rafael, CA – Our Local Coverage Area
We serve San Rafael and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Aluminum Fence in San Rafael
Most residential aluminum fence jobs in San Rafael take two to four weeks from signed estimate to final walkthrough. Permitting adds one to two weeks if your run needs city review, and material lead time on non-standard colors can add another week. Call (866) 320-2646 for a timeline based on your lot.
Sometimes. A side- or rear-yard fence within the height limit often needs no permit, while a front-yard fence or one over the height threshold does. Because San Rafael’s older neighborhoods layer city review with overlay scrutiny, we check the specific rule for your lot before we file, and we pull any permit under our name. Call (866) 320-2646 and we’ll tell you what your address requires.
In most cases, yes. We call in the utility locate before digging, and on established San Rafael lots that’s how we avoid irrigation lines and old stubs. If a utility sits exactly where a post needs to go, we shift the post spacing rather than move the line. Call (866) 320-2646 to walk your property first.
Aluminum fence installation in San Rafael runs $4,000 to $10,000, with the exact figure set by footage, grade, gate count, panel grade, and whether an old fence has to come out. The low end covers a straightforward backyard run on flat ground. Call (866) 320-2646 for a free on-site estimate with a line-item quote.
Every aluminum fence project we install is covered by our 730-Day Done Right Promise: if it’s not done right, we make it right. Our technicians have up to 12 years of experience, and the manufacturer’s finish and material warranty on the panels passes through to you. Call (866) 320-2646 with questions about coverage on your job.
Get a Free Aluminum Fence Estimate in San Rafael
Call (866) 320-2646 to schedule a free on-site estimate for your aluminum fence in San Rafael. We’ll measure the run, check the grade and soil, confirm what the city requires for your address, and hand you a written line-item quote with the total on it. Calls are answered by a live person, and the price we quote is the price you pay.
Written by the team at Groundwork Construction Co.