Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Walk-In Showers & Shower Remodeling in San Bruno, CA: What It Takes and What It Costs
Walk-in showers & shower remodeling in San Bruno generally runs $9,000 to $28,000 for a full bathroom scope, or $4,500 to $12,000 when the job is a stand-alone walk-in shower with new waterproofing, pan and glass. Plan on two to four weeks of working time for most San Bruno showers, longer if the drain or valve has to move. Call (866) 320-2646 and we’ll walk through your actual bathroom and give you a real number, not a ballpark over the phone.
How the Job Actually Runs, Day by Day
Most contractors hand you a start date and a promise. Here’s the sequence we follow, and where you have to make a decision.
- Days 1-2: Demo and inspection. We pull the old surround, pan and glass, then open the wall around the valve and drain to see what’s behind it. This is where the surprises live: rotted framing, a pan that was set on drywall instead of backer board, a 1950s drain that won’t accept a modern liner. You’ll see photos before any change is priced.
- Day 3: Rough plumbing and blocking. The new valve and drain get set, and we add solid blocking wherever grab bars or a bench may go later. If you want a bench, niche or a second showerhead, this is the last easy moment to decide. After the wall closes, it gets expensive.
- Days 4-6: Waterproofing. A bonded membrane or a foam pan system goes in, sealed at every seam and corner. This is the stage that decides whether your shower lasts twenty years or leaks into the ceiling below in five. We flood-test before tile ever goes up, and you can inspect it.
- Days 7-11: Tile or panel finish. Large-format porcelain, a classic 3×6 subway, or a solid-surface panel system. Panel systems go faster and cost less; tile gives you more design control and a longer service life. Grout lines, curb height and linear drain position all get locked here.
- Days 12-14: Glass, trim, final walk. Frameless or semi-frameless glass templated and installed, fixtures set, caulk lines finished, and a punch walk before we call it done. Glass tempering is the usual cause of any slip in the schedule.
Permits and inspection sit across the whole sequence. In San Bruno, a shower that involves moving the drain or valve typically needs a plumbing permit and an inspection before the wall closes – we schedule that so you’re never waiting on a callback while your bathroom sits half-finished.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Choices That Actually Shape the Result
Every shower comes down to a handful of decisions. Here’s the honest trade-off on each.
- Tile vs. solid-surface panels. Tile runs higher on labor and takes longer, but gives you any look you want and holds up for decades if the waterproofing is right. Panels cost less and go in faster, with fewer grout lines to scrub. For a low-maintenance household, panels win; for a resale-minded remodel, tile usually does.
- Curb vs. curbless. A curbless entry is the safest and most modern option, but it means recessing the floor framing or using a linear drain, which adds cost and complexity. A low curb is the practical middle ground for most San Bruno homes.
- Glass. Frameless looks best and costs the most. Semi-frameless saves real money and still reads clean. Either way, the glass is templated after tile, not before.
- Fixtures and valve. A thermostatic valve and quality trim from a brand like Grohe holds temperature and lasts; a builder-grade valve is where leaks and drips start. This is also where the drain style gets set – linear drains cost more but solve the curbless problem.
- Bench, niche and grab bars. Best decided at rough-in. Adding blocking later means opening the wall again.
If the shower is part of a full Bathroom Remodeling in San Bruno project, we sequence the shower with the rest of the room so the trades aren’t stepping over each other.
What Walk-In Showers & Shower Remodeling Costs in San Bruno, CA
Here’s the line-item reality for a San Bruno shower, so you can see where the money goes:
| Scope | Typical range |
|---|---|
| Shower replacement (same footprint, new pan, tile, glass) | $3,000-$8,500 |
| Tub-to-shower conversion | $3,500-$10,000 |
| Walk-in shower installation (new configuration) | $4,500-$12,000 |
| Full bathroom remodel including walk-in shower | $9,000-$28,000 |
| Small bathroom walk-in shower scope | $5,000-$12,000 |
What pushes a San Bruno job toward the top of that range: relocating the drain or moving a wall, upgrading to a curbless floor, large-format tile with a linear drain, and any hidden rot once the wall opens. What keeps it low: keeping the plumbing in place, a panel system instead of tile, and a semi-frameless door.
Your written estimate spells out demo, waterproofing, tile or panel, glass, fixtures and permit scope. It doesn’t include unexpected structural repair or a change in glass size after templating – both get priced and approved with you before work continues. Our bathroom remodeling service runs on upfront pricing, the number you see is the number you pay, and every shower is backed by the 730-Day Done Right Promise.
See the difference
Before
After
Before
After
Before
AfterWhat San Bruno Homes Specifically Do to This Job
San Bruno’s housing stock shapes these jobs in ways you won’t see on a generic page. The Crestmoor neighborhood was ground zero for the 2010 PG&E gas pipeline explosion, and the rebuilding and mandatory seismic retrofit wave that followed still defines how permits and inspections run across the 94066 zip today. Contractors here have to know the post-2010 retrofit requirements cold, and any digging near the Crestmoor blast zone can trigger PG&E gas line clearance procedures that stall a project. That matters even on a shower: if the scope shifts a drain through the slab, you may fall under utility clearance rules that a contractor working another Peninsula city never thinks about.
Homes in Crestmoor and the surrounding blocks are mostly post-WWII single-family houses from the 1940s and 50s, many rebuilt or retrofitted after the explosion. So we walk into two very different showers on the same street: brand-new seismic-compliant structures, and older homes that still need foundation bolting and shear walling before we touch the bathroom. The fog belt and steady onshore winds off the Pacific push moisture into exterior sheathing and trim, so proper flashing and weather-resistant detailing at the shower wall matters more here than in a dry inland climate. If your project grows beyond the bathroom, homeowners often pair this with Roof Replacement & Installation in San Bruno or Metal Roofing in San Bruno while the scaffolding is already up. We cover San Bruno and the surrounding Peninsula, and you can see the full scope of Bathroom Remodeling we handle.
Serving San Bruno, CA – Our Local Coverage Area
We serve San Bruno and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Walk-In Showers & Shower Remodeling in San Bruno
Most walk-in shower projects in San Bruno take two to four weeks of working time. A straight replacement in the same footprint runs closer to two weeks; a reconfigured shower with a moved drain or curbless floor runs three to four. Permit inspections and glass templating are the usual causes of any extra days. Call (866) 320-2646 and we’ll give you a schedule against your actual bathroom.
Yes, if the scope moves plumbing, electrical or structure, you need a permit and an inspection. A cosmetic swap of tile and glass within the same footprint sometimes doesn’t. We pull the permit and pass the inspection as part of the job, so you’re not chasing the city yourself.
Yes, in most cases. Keeping the drain and valve where they are is the single biggest cost saver, taking a job from the high end of the $4,500-$12,000 range down toward the low end. We confirm the existing drain and valve condition during demo before we commit to that plan.
Walk-in shower installation in San Bruno runs $4,500-$12,000, and a full bathroom remodel including the shower runs $9,000-$28,000. The variables that move it are footprint size, whether the drain or valve relocates, tile vs. panel finish, and any hidden rot found at demo. Call (866) 320-2646 for an exact quote – estimates are free.
Every shower we build is covered by our 730-Day Done Right Promise – if it’s not done right, we make it right, and it’s one of the longest workmanship guarantees in the residential construction space. That covers the waterproofing, tile and install work we perform.
Get a Real Number on Your San Bruno Shower
Call (866) 320-2646 to schedule a free on-site estimate for your walk-in shower in San Bruno. We’ll look at the existing drain and valve, talk through tile versus panel and curb versus curbless, and hand you a written line-item quote with the permit scope spelled out. No pressure to sign on the spot. Live person, 24/7, whenever you call.
Written by the team at Groundwork Construction Co.